1. When tying the thread of the water droplet wheel, first turn the side cover clockwise, take off the thread spool and thread cup, take off the thread, and pass the thread through the thread outlet at the front end, and then remove the thread from the thread outlet. Pass one hole in the cup and pass through the other hole to form a tight knot, which will not cause tightness after catching the fish.

2. Next, gently turn the thread cup, let the thread rotate twice on the thread cup, pull out the thread end and tie a live rope sleeve, and fix the thread cup inside the live rope sleeve. The more the outer thread is pulled, , the thread on the thread cup will be tighter. After the rope knot is tied, tie a few more knots on the thread end, and then put it on the thread.

3. After tightening the PE line, rock the wheel to reel in the line. Note that the tip of the lure rod and the PE reel are straight and have no angle. During the reeling process, the tip of the fishing rod should be facing the line. Pan, and finally wind the thread close to the inside of the wheel until it is eight minutes full.

It is very suitable to use a PE line with a drip wheel. The PE line is easier to handle when fishing. However, when you first start learning lure fishing, it is best to use nylon line to practice casting. The cost of nylon line is low. , which can reduce the frequency of line explosion. The drip wheel is easy to cast, stable when thrown into the fishing spot, very accurate in entering the water, and strong in retrieving the line, but you need to practice more throwing skills when you first start learning.