White oil 150g, olive oil 150g, coconut oil 100g, palm oil 100g, sodium hydroxide 73g and water 175g.
The finished soap is hard, thick, fine in texture, foamy and stable, and not easy to collapse in use.
Saponification time: 20-30 minutes
Maturity: 3 ~ 4 weeks
Suitable for skin: general skin.
Formula 2
White oil 160g, mustard oil 140g, coconut oil 140g, olive oil 30g, honey wax 30g, sodium hydroxide 70g and water 170.
Mustard oil and olive oil are fine in foam, and the finished products are moist and clean and hard in texture.
Saponification time: 20-35 minutes
Maturity: 4 weeks
Suitable for skin types: all skin types.
Formula 3
Sunflower oil 100g, mustard oil 150g, coconut oil 150g, palm oil 100g, sodium hydroxide 74g and water 180g.
Low cost and good effect. Sunflower oil moisturizes, mustard oil is mild, and its foam and hardness are moderate.
Saponification time: 30 minutes
Maturity: 3 ~ 4 weeks
Suitable for skin: ordinary skin
Formula 4
The finished soaps made of castor oil 150g, coconut oil 120g, palm oil 200g, honey wax 30g, sodium hydroxide 72g and water 170g showed transparent effect, with many foams, but they were soft and difficult to demould. Hard oil such as palm oil can balance hardness, and beeswax helps demoulding. When using, keep the soap dry to avoid softening.
Saponification time: 30 minutes
Maturity: 6 ~ 8 weeks
Suitable for skin: medium and oily skin.
Formula five
Olive oil 300g, cocoa butter 100g, coconut oil 100g, honey wax 30g, sodium hydroxide 75g and water 180g can soften the skin, which is a good material for making soap and skin care products. Before making, the solid cocoa butter and beeswax should be melted. Be careful not to heat them directly.
Saponification time: 35-40 minutes
Maturity: 4 ~ 5 weeks
Suitable for skin: moderate and dry skin.
Production method:
Glass: used to stir raw materials. It is best to choose heat-resistant glassware because of fever in production. Never use aluminum products.
Soup spoon: used to dissolve caustic soda, and can also be replaced by a stirrer. Aluminum products are also taboo.
Agitator: used to stir raw materials, can be replaced by a large spoon, avoiding aluminum products.
Mould: milk box, packaging of potato chips, plastic box, etc.
Dissolve caustic soda with water, put water and caustic soda in a container and stir until the water becomes transparent. It should be noted that foaming and heating will occur during the mixing process.
While adding oil, stir, and gradually add oil while stirring after the caustic soda is completely dissolved. Stir with a blender 10 minutes or so.
Put all the remaining materials in and stir again, and continue to stir carefully for about 10 minutes until they are completely and evenly distributed. At this time, the liquid began to thicken gradually.
Stop stirring, and after two or three minutes, inject it into the mold.
Leave it intact for 1~2 days and in a warm place for 1~2 days. At this time, the liquid produces a chemical reaction in the mold. Please don't touch it with your hands.
Take out the soap from the mold. You can insert a knife or scissors into the mold to take it out smoothly.
Cut into squares of appropriate size, put them in a ventilated place, avoid direct sunlight, and put them for more than a month before the production is completed.