I. Management Regulations for Acceptance Maintenance Room 1. The staff should be strict with themselves and take care of all the facilities and articles in the inspection and maintenance room. The acceptance curing room should be kept quiet and tidy. 2. The experimental instruments should be cleaned in time after use, and the redundant reagents should not be poured back into the original bottle to avoid pollution. Reagents or instruments should be put back after use. 3. All kinds of instruments are kept by the mechanic, who is responsible for the maintenance of the instruments. 4. Before using all kinds of precision instruments, you must read and learn the operating instructions or standard operating procedures of the instruments and use them after training. Clean and maintain the instrument after use, put it back after counting the accessories, and finally fill in the use registration. 5. The original records should be filled in the records during the inspection, and cannot be temporarily recorded and copied on other papers or notes. 6. Personnel of other units shall not enter the acceptance maintenance room without permission. Second, the acceptance of curing room operating rules 1. The safe operation of the acceptance curing room is 1. 1. Before inspection, you must be familiar with the working principle and precautions of the equipment, and check whether the installation of the equipment and instruments is in good condition. 1.2, the inspection spirit should be concentrated, don't chat with others, and it is forbidden to leave the job during operation. 1.3, contact with corrosive and irritating substances, not direct contact with hands, tools should be used. 2. The management of equipment and instruments in the acceptance curing room shall be implemented according to relevant requirements. 3. Inspection and maintenance room hygiene 3. 1. Strictly control personnel to enter the acceptance and maintenance room, and non-personnel in this room are not allowed to enter without permission. 3.2 Before entering the acceptance curing room, change shoes and keep the acceptance curing room clean. 3.3. Temperature and humidity control should be carried out in the acceptance maintenance room, and the temperature