The membership card is special and meaningful in terms of not having to wait in line, being able to enjoy discounts on consumption, and being able to experience some services that ordinary users can't enjoy.

membership card

introduction:

Member's Card generally refer to ordinary identification cards, including membership authentication in shopping malls, hotels, fitness centers, restaurants and other consumer places. They are widely used, and can be applied to identification cards where identification is required. Membership cards are classified into VIP membership cards, membership gold cards, ordinary membership cards, third-party membership cards, etc. Members who use membership cards can enjoy corresponding discounts, points, coupons and other benefits when spending.

Instructions for production:

1. The correct draft is coreldraw file, which has been converted into bitmap after special effects, and the characters, symbols and patterns must be converted into curves.

2. specifications of inner frame: 85.5mm*54mm, specifications of outer frame: 88.5mm*57mm, and rounded corners of cards are 1.2 degrees.

3. The small convex code is 13 font, and the large convex code is 16 font, which can be expressed in bold. The small convex code and the large convex code can only contain 19 spaces at most. The embossed code can be bronzed with silver or other gold and silver, and the embossed code can be made for special requirements.

4. The margin between the convex code and the card must be greater than 5mm, the inner frame (top and bottom) of the magnetic stripe is 4mm, and the width of the magnetic stripe is 12.6 mm..

5. magnetic stripe card: don't press the convex code on the magnetic card on the back, or the magnetic stripe will not be able to swipe the card.

6. Don't press the convex code design position on the bar code on the back, otherwise the bar code data can't be read, and the bar code card is left blank according to the bar code model provided by the customer.

7. color gradation: the ideal stage range is 18%-85%. if the highlight part is lower than 18% or the dark tone part is higher than 85%, the color gradient is poor.

8. The color mode should be C, M, Y, K, with pure black characters on the front and back or K111 on the black background, with white characters on the solid blocks and white edges.

9. The thickness of lines shall not be less than 1.176mm, otherwise the printing will not be presented.

11. The color of shading or base map should not be lower than 8%, so as not to be presented when printing the finished product.