Problems needing attention in changing kitchen into hydropower: the design of kitchen hydropower
When carrying out water and electricity transformation again, the owner must think clearly about which appliances he needs in his kitchen in the future and where these appliances are generally placed. Communicate with the designer after the corresponding planning, and decide the kitchen decoration scheme and hydropower transformation scheme. At the same time, we should also consider what kind of electrical appliances may be acquired in the future, whether it is necessary to reserve corresponding positions, and so on.
Precautions for changing water in kitchen: hot water supply in kitchen
The hot water supply in each community is different, and the owner needs to determine whether to heat the hot water centrally or by himself when decorating. At the same time, if there is less hot water in your home, how to use it, and after these problems are clarified, you can decide the direction of the water pipe.
Precautions for changing water in the kitchen: what should I do when I enter the kitchen?
Many owners' kitchens are either waterproof or floor drain. In this case, when choosing a sink, you should pay attention to it, and you must choose a sink with overflow. In this case, even if the faucet leaks, it will not cause your home to overflow Jinshan or hurt the neighbors downstairs.
Matters needing attention in improving kitchen water use: high-power solution for kitchen
Some kitchens use high-power appliances such as ovens and microwave ovens. At this time, we should pay attention to the wiring problem in the kitchen. The wires used by general high-power electrical appliances are at least 4 square millimeters higher than the national standard. If the 2.5 mm square conductor is still used, it is likely to lead to overheating, short circuit and even fire.
Precautions for changing water in the kitchen: Pay attention after the renovation of the kitchen waterway.
After the renovation of the kitchen waterway, it must be suppressed. Generally, it needs to be 1.5 times (0.5-0.8MP) of the working pressure of water supply. If you hold it for half an hour, there will be no leakage and the pressure drop will not exceed 0.05MP.
On the issue of changing the kitchen to water and electricity, we must do a good job in the early stage planning, consider what electrical appliances the kitchen needs, and rationally arrange the kitchen circuit; As for the improvement of the water in the kitchen, the most important thing to consider is the launching of the kitchen. To ensure that the kitchen sewer is unblocked, there will be no infiltration in the kitchen. Of course, the kitchen will use a lot of materials in changing water and electricity. It is suggested to choose safe and high-quality wires, sockets, floor drains, pipes and other materials to at least ensure the durability of the reconstructed kitchen.