Ronghui signs pointed out that the installation of signage according to the installation of the basis and production process can be subdivided into different, the following is a brief introduction to the signage commonly used 8 kinds of correct installation methods.
Signage commonly used 8 kinds of correct installation methods
First, the signage installation method of paste
This way is more widely used, the use of adhesive glass glue, AB glue, foam adhesive, universal adhesive, sponge adhesive, double-sided adhesive, chloroform, structural adhesive and so on. According to the different materials and foundations, the length of time, the difference in the installation environment, indoor and outdoor dry and wet, temperature difference and other situations to choose the right adhesive.
Second, the signage installation method of prosthetic paste hanging
This is also used for some of the folded edge of the sign, such as like the wall base is marble, glass, stainless steel, etc. does not allow perforation, and is more sturdy and flat, it is more suitable to use this way. First of all, measure the position, use AB glue to organic edge strips or angle aluminum and other materials glued to the wall, and then the logo folded edge to hang, fine-tune the position, fixed with glass glue can be.
Third, the signage installation method of hanging fixed
This is for some of the folded edge of the logo, the volume is larger, heavier, with foam filling paste can not be installed by the way. First determine the point of drilling, drilling with an impact drill, nailed to the plug and self-tapping screws, only 1 screws, must be in the middle of the upper edge of the signage holes to maintain the level, and then the sign of the folded edge of the screws to hang, adjust the position, sealed around the glass adhesive fixing can be.
Fourth, the signage installation method of decorative screws fixed
This way is designed in advance, the design has been clearly indicated, generally such as acrylic panels clip painting more than this way, the main screws must be accurately positioned, otherwise it can not be installed correctly.
Fifth, the signage installation method of pulling the explosion screws fixed
This method applies to the ground base for the concrete structure, the logo does not need to move the situation, such as road signs, parking lot signs are mostly used in this way.
Six, the signage installation method of hanging
This way of hanging chain materials used mainly chains, steel cables, hanging fish wire, ties, etc., according to the indoor and outdoor environment, signage production weight and other special requirements of the use of suitable lifting materials.
Seventh, the signage installation method of the floor
According to the design requirements, the sign will be placed in the appropriate location.
Eight, signage installation method of landfill
For the ground for the soil structure, the logo does not need to move the situation, according to the size of the logo, high and low, to determine the size of the pit using the number of concrete, the construction of the need to pay attention to the surrounding environment, the logo landfill is complete, must clean up the scene, restore flowers and grasses and watering, shall not be damaged.
I believe that after understanding the above ways and means, you must have gained, the installation method of signage production is not fixed, according to the actual installation situation, and sometimes combined with a variety of methods in one in order to better complete the installation process of signage production.
Xi'an Ronghui signage factory is a signage system planning - design - production - installation of four "one-stop" full-service professional signage system manufacturing supplier, warmly welcome all walks of life to visit the factory.