The kitchen fume is very heavy, so it is necessary to install a fume purifier. Next, Xiaobian will tell you how to disassemble and wash the fume purifier and how to maintain it.

1. How to disassemble and wash the oil fume purifier

Step 1: Turn off the power supply

Before cleaning the oil fume purifier, be sure to turn off the power supply and discharge the charge in it. Never think that turning off the power supply will not affect the safety, or you will regret it if it is dangerous and affects your health. After turning off the power supply, you should also use a screwdriver to contact the anode and cathode of the electric field and discharge the charge.

Step 2: Unscrew the bolt and pull out the electric field

When the power supply is turned off, unscrew the bolt for fixing, open the maintenance door, and then pull out both sides of the electric field by hand. When the electric field is about to be pulled out, hold the end with your hand to prevent it from suddenly falling off and damaging the electric field.

Step 3: Disassemble the fittings for easy cleaning

Some fittings of the purifier should be removed, especially the insulators, because they are easy to be damaged after being soaked. In addition, it is also convenient to clean other fittings, such as cathode needle and anode cylinder.

step 4: electric field cleaning, i.e. soaking and washing

cleaning the tank container, and the shape of the used appliance is larger than that of the electric field. When cleaning, avoid oil pollution directly to the floor, and it is best to move the purifier to the toilet for cleaning. Cleaning can be scrubbed with mixed solution of caustic soda and hot water, plus high-pressure water gun and water, and the washing time depends on the oil pollution. Remember to dry it in the sun after cleaning.

Step 5: Inspection and cleaning of insulators

The oil on the insulator surface should be cleaned. The cleaning method is to spray alcohol on the insulator first, and then dry it with a dry rag.

2. How to maintain the oil fume purifier

1. The electric field of the oil fume purifier uses a cylindrical honeycomb structure, which greatly improves the effect of removing oil fume. When using it, the electric field damage should be avoided as much as possible.

2. The electric field rigidity of the cylindrical honeycomb is good, and it is easy to disassemble and assemble. Pay attention to reassembling it in the original way during daily cleaning, and don't make a mistake, so as not to affect the normal use of the lampblack purifier.

3. The noise of the oil fume purifier is low when it is running, but if the internal parts are damaged, the noise will increase. At this time, it is best to find a professional to check it.

4. The oil fume purifier has high safety factor and low radiation. Pay attention to cleaning and maintenance when using it at ordinary times, and remember to cut off the power supply when not in use.

5. The oil fume purifier has high purification efficiency, but after being used for a long time, there is a lot of dirt residue on the filter screen, which will reduce the purification effect. At this time, it is best to replace the filter screen or remove it to clean it.

when the oil fume purifier is used for a long time, there will be a lot of dirt on the surface and inside. If it is not cleaned in time, the temperature will be too high, which will cause a fire. The above is the disassembly and maintenance method of the lampblack purifier, and I hope it will help everyone.