Chengdu product introduction-regarding the installation and application of energy-saving stoves, the original stoves need to be reformed, and our products are superstitious and reasonable in design, which makes the installation very convenient! Just slightly improve the original stove! It can be modified in less than ten minutes! The modification method will now be explained as follows: 1. Remove the water pan and cooker head of the original cooker, and remove two nozzles that open the air outlet electrically with gas plates. The line with the switch is a small fire eye, and the left or right is a big fire eye. Second, use a wrench (or needle-nosed pliers, etc. ) Knock the iron snorkel under the cooker quietly to loosen the cinder and rust attached to the iron snorkel, and then release gas to let the cinder, rust and other sundries inside be discharged. The purpose of this step is to prevent debris such as cinder and rust from blocking the small hole of the nozzle of the equipment. Turn on the gas stove switch first. Then turn on the fuel tank switch. It takes two to three seconds, remember! ! ! Third, when changing the single-tube energy-saving stove, plug the fire hole with screws (be sure to add a raw material belt on the thread to avoid air leakage. Raw material belt (available in plumbing and building materials stores), connect the coal four seasons energy furnace with the air outlet (i.e. small fire hole) aligned with the switch handle, and tighten it (raw material belt must be added). If the double-tube energy-saving stove is replaced, just put the nozzles on the device in turn according to the size and fire eye of the stove. It is worth noting that we must distinguish between big and small fire eyes. Note: it is not necessary to tighten the screw too hard to avoid the screw breaking. Four, after the installation, according to the use of home cooking utensils (flat pot or round pot), properly adjust the top and bottom of the stove, generally 1.5-3 cm away from the bottom of the pot is the most appropriate. 5. After the above tasks are completed, it can be used normally. Just check if the stove goes out. When the furnace goes out normally, the appearance of the furnace should be red within 3-5 seconds. If the red color is slow or not red for a long time, it is necessary to increase the pressure of the liquefied gas bottle a little, so as to achieve the ideal energy-saving effect. Please explain by SMS or telephone that the information comes from special classified information. All the contents of unconventional classified information are published by users, and we do not guarantee the products and services promised by sellers. If the products and services provided by the seller are prohibited by law, please be cautious, and the risk of fraud is extremely high.