Installation method of embedded disinfection cabinet ☆ When handling the disinfection cabinet, it should be lifted from the bottom of the cabinet, and the door handle should not be used as a support for handling; ☆ The tableware disinfection cabinet can be installed at the lower part of the cabinet foundation or the upper part of the vertical cabinet as required. The bottom of the cabinet should be supported by a platform, and it can't be fixed only by screws at the door frame. ☆ If an embedded gas stove is installed on it, try to avoid the battery box, universal joint and gas pipe from touching the disinfection cabinet. For the embedded disinfection cabinet, the back or side of the cabinet is required to have ventilation holes with a diameter greater than 120; ☆ Be careful not to tilt. Just bought a disinfection cabinet, you must pay attention to the details when using it. Before disinfection, the tableware should be washed and dried, which not only saves time and electricity, but also prolongs the service life of the electric heating tube. Tableware should be placed with a proper gap, which is conducive to the full flow of ozone in the disinfection room and enhance the disinfection effect. In addition, the bearing capacity of each shelf is limited, generally 5kg. Be careful not to be overweight when placing. Don't open the cupboard door when the disinfection cabinet is working to prevent ozone gas from leaking into the air and causing pollution; Second, when the high-temperature disinfection cabinet works, the outside temperature is high and it is easy to burn. You have to wait until the work is over and the heat dissipates, then open the cupboard door to get the tableware.