First of all, the kitchen line problem we must pay more attention in the decoration , although we are not a professional, but because this is where we live later, there are certainly many things are closely related, so there is nothing wrong with a little more understanding. The line must meet the hidden, safe features, we can think of some, but more specific or let the professionals to solve, do not take your little bit of knowledge to challenge other people's rice bowl.

Kitchen renovation is mainly water and electricity must be prioritized and planned, kitchen if the beginning of the planning is not good, such as water heater if the hood is too close to the words, or natural gas pipe is too close to the words will be required by the relevant departments to re-modeling, such as less sockets. In the kitchen plumbing layout generally take into account the hood, microwave oven, rice cooker and so on.

To the kitchen water line before the installation of the first to design the location of the water installation, height. How about and who is related to the sink and other places to consider the location of its installation, followed by the installation of water pipes, in the installation of hot and cold water pipes should pay attention to the reasonable distinction between hot and cold water pipes in the distinction between hot and cold water pipes should pay attention to a number of points: cold and hot water on the water mains height is the same, cold and hot water on the water mains should be two centimeters above the wall.

All circuits should be away from water, fire and gas piping, and water, fire at least 40cm distance, and gas piping at least 30cm distance. The socket used in the kitchen must be grounded to prevent leakage of electricity causing safety hazards. The layout of the waterway must follow the principle of vertical and horizontal, and the water and electricity road map must be saved.

Weak power should be shielded cable, the second decoration line layout needs to be re-slotted wiring , most of the strong and weak power can only go from the ground to the pipe, and the strong and weak power pipe cross, close parallel and other situations are very common. If the weak power using non-shielded cables, may cause signal interference;

Circuit alignment design principles to grasp the "shortest distance between the two ends of the line" principle, do not intentionally around the line.