Legal analysis

If the flow rate is far below the minimum flow rate to ensure accuracy, there will be no output (such as vortex flowmeter) or the output signal will be cut off as a small signal (such as differential pressure flowmeter), which is unfavorable and unfair to suppliers. In order to prevent the loss of benefits, for a specific set of thermal energy metering equipment, the supply and demand sides often agree that a certain flow value is the "agreed lower limit flow" according to the flow measurement range and the achievable range, and agree that if the actual flow is less than the agreed value, it will be charged according to the lower limit flow. The metrological administrative department of the people's government at or above the county level may set up metrological verification institutions according to needs, or authorize metrological verification institutions of other units to perform compulsory verification and other verification and testing tasks. Personnel who perform the verification and testing tasks specified in the preceding paragraph must pass the examination. This function is usually realized in the flow display instrument. The metrological administrative department of the local people's government at or above the county level shall, according to the needs of the local area, establish public standard instruments of measurement, which shall be used after passing the examination presided over by the metrological administrative department of the people's government at a higher level. Enterprises and institutions may, as required, establish standards of measurement for their own use, and the highest standards of measurement shall be used after passing the examination presided over by the metrological administrative department of the relevant people's government. Metrological verification shall be carried out on site in accordance with the principle of economy and rationality. Metrological verification must be carried out in accordance with the national metrological verification system table. The national metrological verification system table shall be formulated by the metrological administrative department of the State Council.

legal ground

Article 37 of the Standardization Law of People's Republic of China (PRC), if the products produced, sold or imported or the services provided do not meet the mandatory standards, they shall be investigated and dealt with in accordance with the provisions of the Product Quality Law of People's Republic of China (PRC), the Import and Export Commodity Inspection Law of People's Republic of China (PRC) and the Consumer Protection Law of People's Republic of China (PRC), and recorded in the credit record. If a crime is constituted, criminal responsibility shall be investigated according to law. Decision of NPC Standing Committee on Amending the Law of People's Republic of China (PRC) on the Protection of Consumer Rights and Interests. Article 51 is renumbered as Article 59 and amended as: "If an operator refuses to accept the decision on administrative punishment, he may apply for administrative reconsideration or bring an administrative lawsuit according to law." In addition, the order of the articles should be adjusted accordingly. This decision shall come into force on March 20 14 15. The Law of People's Republic of China (PRC) Municipality on the Protection of Consumer Rights and Interests is revised according to this decision and re-promulgated. Interim Measures for Handling Complaints and Reports in Market Supervision and Management Article 1 In order to standardize the handling of complaints and reports in market supervision and management and protect the legitimate rights and interests of natural persons, legal persons or other organizations, these Measures are formulated in accordance with the Law of People's Republic of China (PRC) on the Protection of Consumer Rights and Interests and other laws and administrative regulations.