1. The upper cabinet of the cabinet shall be fixed in different ways according to different walls. The length of the backing hanging plate is about the length of the upper cabinet minus 10 cm. Two reinforcing nails are used for the length of the backing hanging plate less than 50 cm, and three reinforcing nails are used for the length of the backing hanging plate less than 80 cm. The length of reinforcement nail should not be shorter than 5cm. When installing stainless steel kitchenware, first adjust the level of the cabinet, and then adjust the hinge to ensure the balance and vertical of the door; The two groups are connected to the cabinet, and the screws should be removed and connected with wooden screws. The cabinets of the two upper cabinets should be horizontal and vertical, and the gaps of the door leaves should be symmetrical; The height of the cabinet from the ground should be greater than1.5m..
2. Adjust the horizontal knob when installing the lower cabinet, and the table top and front of each cabinet should be on a horizontal plane; When connecting two cabinets, use wooden screws. In the case of pipes, valves, etc. The back should be punched and scribed on the back plate to avoid related equipment, and there should be no sawtooth phenomenon at the hole edge.