Current location - Recipe Complete Network - Catering industry - Construction technology of non-slip floor tile ground
Construction technology of non-slip floor tile ground

Calculate how much it will cost to decorate your home

1. Clean the sundries, residues and dust on the ground at the grass-roots level, and clean the oily places with detergent.

2. Cement mortar should be used to repair and level the collapsed pits, and the surface can be roughened twice with wooden crabs. And arrange the anti-skid bricks along the direction of bearing and bearing, and the joint width should meet the requirements. If

the edges at both ends are inconsistent, the dimensions can be measured and cut into edging bricks. After determining the arrangement, play the control line every 3-5 bricks.

3. Clean the matched tiles, soak them in clean water for 2-3 hours, and take them out to dry. After the control line is played on the base surface, the bricks can be laid in a certain order. When laying bricks, it should be noted that the positioning belts in the horizontal and vertical directions should be laid first, and every 15-21 blocks are the positioning belts. Then lay the floor tiles in the same direction to ensure that the floor tiles are consistent with the control line and keep flat and dense.

4. When laying the floor tiles, you need to sprinkle some water with a watering can after each paragraph is paved, let it stand for 1.5 minutes, and then hammer it with a wooden hammer in the order of laying the tiles. In the process of hammering, while leveling and compacting with a spirit level, after the floor tile is compacted, the line can be pulled, and the brick joints are straightened first, and then the horizontal joints are straightened to ensure that the joints are straight and well-connected. After the joint of ceramic tile is adjusted, it shall be leveled with a wooden hammer, and the residual slurry in the joint of ceramic tile or the mortar on the surface shall be erased.

5. After the floor tile is laid for 4 hours, it can be wetted with water. At the same time, the joint of the brick is smeared with fine mortar, embedded and calendered, and then the brick surface is wiped clean with cotton yarn.

enter the area and get the decoration quotation for free.