the wiring mode of the fire-fighting quick exhaust valve can be different according to the specific equipment and manufacturers. The following are the possible wiring steps in general:

1. Turn off the power supply: before any electrical wiring, make sure to turn off the relevant power supply to ensure safety.

2. Prepare necessary materials: prepare required wires, cable sleeves, terminals, etc. according to the installation requirements.

3. Connect the power supply: Connect the power cord to an appropriate power outlet, usually an inlet terminal.

4. Connect the control line: Connect the control line according to the schematic diagram or wiring diagram in the equipment manual.

5. Use terminals: If necessary, you can use appropriate terminals to connect wires to ensure reliable connection.

6. Installation of cable sleeves: Install wires and control wires into appropriate cable sleeves to protect wires and provide a clean appearance.

7. Reconnect the power supply: Reconnect the power supply after ensuring all the wiring is safe and reliable. Please note that the above steps are only general guidance, and the specific wiring steps may vary according to the equipment model and manufacturer. Therefore, before any electrical wiring, it is strongly recommended that you refer to the installation instructions of Fire quick exhaust valve or consult professional fire equipment installation technicians to ensure correct and safe wiring.