Current location - Recipe Complete Network - Catering industry - Installation method of motor of side suction range hood
Installation method of motor of side suction range hood
Side-suction range hood is a new type of oil fume purification equipment, and the motor of the equipment is its core component, so the installation technology of the motor is very important. The following is the installation method of the motor of the side suction range hood:

1. First, confirm the air inlet and air outlet of the range hood to ensure the correct installation direction.

2. Then, the upper and lower tubes of the motor need to be installed together. It should be noted that the two pipes must be installed on the same plane. And the joints should be tight to prevent air leakage.

3. Next, put the motor into the shell of the range hood, and then install two brackets of the motor on the shell, which need to be fixed with screws.

4. Next, it is necessary to install the wind wheel of the motor on the motor shaft and tighten the screws to prevent the wind wheel from loosening.

5. Finally, connect the air inlet of the motor with the air inlet pipe of the range hood, and connect the air outlet pipe with the air outlet pipe for debugging to ensure the normal operation of the range hood.

It should be noted that the installation height and position of the motor depend on the size of the range hood and the ventilation of the kitchen. At the same time, it is necessary to maintain the motor regularly, clean the filter screen and wind wheel of the motor, and check whether the motor works normally.