The installation of bathroom ceiling lights
The first step: choose a good location
The first thing you need to do to install ceiling lights is to determine the location of the ceiling lights. For example, the living room, dining room, kitchen ceiling light is best installed in the center, so that the position of the light is more average. The bedroom, taking into account the mosquito nets and the impact of light on sleep, so try not to install ceiling lights above the bed.
In addition, ceiling lamps need to select the masonry structure that can withstand the weight of the ceiling lamp wall or ceiling installation, try not to choose a wooden wall, so as not to have a long time to avoid the risk of falling.
Second step: remove the ceiling lamp cover
The ceiling lamp cover, in general, the ceiling lamp cover has a rotating and buckle stuck in two fixed way, remove the time to pay attention to, so as not to break the ceiling lamp, remove the cover after the lamp will be removed by the way, to prevent the installation of broken lamps.
Step 3: Install the base
The base is placed in a predetermined installation position, mark the wall with a pencil, then take away the base, use a drill to drill holes in the marked position, and then install the expansion bolts used to fix the base in the holes, pay attention to the diameter of the drilled holes and the depth of the buried bolts in line with the specifications. Afterwards, put the base back to the intended location, fixed can be.
Step 4: Connect the wires
After fixing the base, you can connect the power cord with the ceiling lamp terminal block, it should be noted that the two wires connected to the power cord with the ceiling lamp, the electrical contact should be good, but also wrapped in black tape, and maintain a certain distance, if possible try not to put the two wires on the same piece of metal under the head, so as to avoid short-circuiting, a danger.
Step 5: Installation of mask pendant
After connecting the wires, you can try to power on, if everything is normal, you can turn off the power to install the ceiling lamp mask. Living room ceiling light also need to install a series of pendants, because each ceiling light pendant is different, so the specific installation method can refer to the product manual. Pendants are usually left over, can be stored after installation, and can be replaced when needed later.
Installation precautions
1, before installation should look carefully at the markings of the lamps and read the installation instructions, install the lamps in accordance with the provisions of the instructions, according to the instructions in the use of the rules of use of the lamps.
2, according to the light source parameters provided by the logo to replace the aging lamp in a timely manner, found that the ends of the lamp red, the lamp jump does not light, the lamp should be replaced in a timely manner to prevent the occurrence of ballast burnout and other unsafe phenomena.
3, the installation of ceiling lamps, we first have to prepare the required installation tools, namely, hammer or drill, wire strippers, pencils, large and small Phillips screwdriver, expansion screws, which the purpose of the drill is to facilitate the pouring of floor holes with the hammer is a little heavy, inconvenient to use, so it is recommended that we use the drill, compact and convenient.
4, in the cleaning and maintenance should pay attention to, do not change the structure of the lamps and lanterns, do not casually replace the lamps and lanterns of the components, in the cleaning and maintenance of the end, the lamps and lanterns should be installed according to the original, do not omit to install, misinstallation of lamps and lanterns parts.