What are the precautions when the grease trap is rebuilt

Adjust the oil-water separator (grease trap) to a horizontal position during installation. Before the first use, the equipment should be filled with tap water, and the water level regulating pipe should be adjusted so that the top of the water level regulating pipe is at the same level as the upper edge of the oil spill tank, and the position of the water inlet pipe should be kept at a certain distance from the sundries separation box to facilitate the removal of the sundries separation box. Introduce oily wastewater, and adjust the water level regulating pipe again until the oil drain pipe only discharges oil and does not drain water. If the position of the oil drain pipe is too low, the equipment cover plate can be opened and the oil can be taken out with tools. When draining oil, first open the oil drain valve, drain some water at the bottom, and then collect waste oil. After adjusting the regulating pipe, please don't touch it at will, otherwise it will affect the effluent quality.

transformation method of grease trap and matters needing attention

The simplest grease trap is made of cement, and the size of the trap needs to be determined. However, in reality, people will find that the simple method of density natural separation is not effective, and the oil will be fermented and hardened after a little long time, and it will have a bad smell. Therefore, the solution is to use aeration or oil-absorbing materials. The grease trap designed by aeration method is suitable for large shopping malls, hotels and other places, and the small grease trap can