What is the installation process of kitchen equipment?
Basic treatment of wall and ground → inspection of installation products → installation of hanging cabinet → installation of bottom cabinet → debugging of water supply and drainage connection → installation of supporting electrical appliances → testing and adjustment → cleaning.
What are the precautions for the installation of kitchen equipment?
1. The installation of hanging cabinets should adopt different fixing methods according to different walls. The length of the backing hanging plate should be the length of the hanging cabinet minus 10 cm. When the length of the backing hanging plate is less than 50 cm, use two reinforcing nails, and when it is less than 80 cm, use three reinforcing nails, and the length of the reinforcing nails shall not be less than 5 cm. When installing, the level of the cabinet should be adjusted first, and then the hinge should be adjusted to ensure that the door is horizontal and vertical. The height of the hanging cabinet should be greater than 1.5m from the floor of the hanging cabinet. When the decorative wire board needs to be added above the hanging cabinet, the vertical plane between the decorative wire board and the cabinet and the door leaf should be ensured. When two sets of hanging cabinets are connected, the screws should be removed.
Connect with wooden screws to ensure that the cabinets of the two hanging cabinets are horizontal and vertical, and the gaps of the door leaves are even. 2. When installing the bottom cabinet, adjust the leveling knob first to ensure that the table top and front of each cabinet are on a horizontal plane. The two cabinets are connected with wood screws, and the back plate is connected with the pipeline. Tables, valves, etc. Punching holes should be made on the back plate to avoid relevant equipment, and the edges of holes should not be serrated.
3. Install a plastic round pad at the drain hole of the bottom plate of the washing cabinet. The joint of the drain pipe should be watertight, and various adhesives should not be used to connect the interface parts.
4. When installing the stainless steel sink, draw a groove on the table according to the model and size of the sink. The joint between the sink and the countertop should be clamped and leveled with hanging screws, and the edge should be sealed with sealant to ensure that the gap between the sink and the countertop is even and watertight.
5. When installing the faucet, you can directly punch holes in the stainless steel plate or other countertops. The installation should be firm, and there should be no water seepage when receiving water.
6. The installation of the range hood shall be subject to the instructions of the range hood manufacturer used, and the dimensions of the hanging cabinet and the range hood shall be coordinated and unified.
The above contents are the installation process and matters needing attention of kitchen equipment that I introduced to you. It can be collected for reference when decorating the kitchen in the future. Even if you don't do it yourself, you can at least help the supervisor.