Current location - Recipe Complete Network - Catering training - How to do the sliding door of the ceiling door?
How to do the sliding door of the ceiling door?
Sliding door is to add a track and pulley above the door and make a guide groove below the door.

At first, sliding doors were only used for sliding doors in bedrooms or dressing rooms. However, with the development of technology and the diversification of decoration methods, the function and application scope of sliding doors are constantly expanding from the traditional panel to glass, cloth, rattan and aluminum alloy profiles, from sliding doors and folding doors to partition doors. In this case, the application of sliding door began to become diverse and rich. In addition to the most common partition doors, sliding doors are also widely used in bookcases, wall cabinets, living rooms, exhibition halls, sliding doors and so on.

1, the hanging sliding door is difficult to handle because the track box is installed first and then the brick is attached, which brings certain difficulties to the construction. Because the track bears a certain pressure, so do the bricks. Over time, it is easy to cause the bricks next to the track to crack. In addition, if in the kitchen, bathroom and other spaces, the track box is easy to shelter evil people from evil practices, and oil smoke and dust will fall on it, which will bring trouble to cleaning.

2. The track box on the upper part of the sliding door should be 12 cm high and 9 cm wide. Like the curtain box, the track box is equipped with a track, and the sliding door can be hung on the track. At present, the height of most doors or doorways is 1.95 to 2.15m. Experience shows that when the height of the door is lower than 1.95m, people will feel depressed and uncomfortable regardless of their height. Therefore, when making a sliding door, the height should be at least 195+ 12=207 cm, and there is enough space to make a track box before considering making a sliding door. Otherwise, it can only be externally hung, that is, the track box is exposed, which is definitely not good-looking, and the gap between Nagato and the wall will also become larger as time goes by.

3. The width of the sliding door is exquisite. The gold size of a normal door is about 80 cm× 200 cm. In this structure, the door is relatively stable. If the height is higher than 200 cm or even higher, it is best to reduce the width of the door or make more sliding doors on the premise of keeping the area unchanged to maintain the stability and safety of the door.

4. Carefully use the sliding door from the floor to the top (open the hanging rail box). Because the swing amplitude is too large when pushing and pulling, the sliding door is easy to deform after a long time, and the deformed back door cannot be opened, which means that it cannot be maintained and used.

5. Because the sliding door is in contact with both sides of the wall or cabinet, there should be no other object blocking the closing of the sliding door at the contact position. For example, the position of the drawer in the cabinet should avoid the intersection of sliding doors, at least higher than the bottom plate1cm; The drawer on the folding door cabinet is at least 15cm away from the side wall. Pay special attention to the power switch and socket on the wall here. If the sliding door is blocked, the position of the switch and socket should be changed.

6. No matter what material is used, the floor must be flat, and the four walls at the door should be horizontal and vertical. Otherwise, the installation rear door will be skewed. The adjustable error shall not exceed 65438 00 mm.

7. Please don't install the corner line in the installation position. The plaster line can be installed on the sealing plate above the closet. If the door is directly above, don't install plaster line.

8. Carpets with a thickness less than 5 mm will be cut off and directly attached to the lower rail. Carpets with a thickness of more than 5 mm can be directly fixed on the carpet with screws if double tracks are installed; If the monorail is installed, the carpet at this position must be cut off, and 3-5 mm thick wooden strips should be put in the carpet in advance, so that the monorail can be directly attached to it.

9. At the junction of wooden floor and ceramic tile, this situation mostly occurs between balcony and living room, and between bedroom and living room. The solution is as follows: 1. Try to install the lower guide rail on the material. 2. Add wood or marble with the same width as the lower rail between the two materials. Threshold stones can also be used in the kitchen.