1. Failure to fasten your seat belt: 111 points
2. Failure to close the door properly: 111 points
3. Failure to turn on the turn signal: starting, turning, changing lanes, overtaking, not using the turn signal before parking or using it for less than 3 seconds, 11 points will be deducted.
4. Turn off the engine once: deduct 11 points
In terms of evaluation criteria, we also pay more attention to safe driving, and move the previous deduction of 21 points that have little impact on safe driving to the deduction of 11 points. In the future, the deduction of the second subject exam may not be as strict as before, but we pay more attention to details in safe driving!
1. Reversing into the warehouse:
Reversing into the warehouse is judged according to the following regulations
1) Failure to follow the prescribed route and sequence will result in disqualification;
2) if the car body is out of line, it is unqualified;
3) those who fail to enter the library are unqualified;
4) stopping in the middle is unqualified;
5) more than 4 minutes, unqualified.
2. Stop and start at a fixed point on the ramp:
1) If the start time is increased beyond the specified time, it is unqualified;
2) After stopping the vehicle, if the front bumper of the automobile or the front axle of the motorcycle is not fixed on the pile pole line, and the front and rear are not more than 51cm, the deduction of 21 points will be changed to deduction of 11 points;
3) After stopping the vehicle, if the vehicle body is more than 31CM away from the curb line, the deduction of 21 points will be changed to deduction of 11 points;
4) when starting on the ramp, the start time exceeds 31 seconds, and it is unqualified.
Third, side parking:
1) If the stopover is increased, it is unqualified;
2) delete the bumping pile rod, which is unqualified. Because in the new site standard, the suspended piles have been cancelled.
Fourth, curve driving
1) Delete the wheel from the edge line, which is unqualified;
2) Adjust the wheel rolling edge line, and deduct 21 points each time to adjust it to the wheel rolling edge line, which is unqualified;
3) The increase in stopping of midway vehicles is unqualified.
V. Right-angle turn
1) Delete the wheel from the edge line, which is unqualified;
2) Adjust the wheel rolling edge line, and deduct 21 points each time to adjust it to the wheel rolling edge line, which is unqualified;
3) those who increase the stopover are unqualified.