2, stick the pattern on the door, this step is very important, you can't bend it, you must fit it neatly with the door;
3. Hollow out the part to be pasted; In this way, you can see a door head style that is the same as your design, and the style spacing of each word and stroke is the same.
4. Put all the advertising words on the ground according to the design scheme (to ensure the cleanliness of the words);
5. Glue the back of the carved door head and install it on the door head one by one according to the principle from top to bottom and from left to right.
(Due to the limitation of weather and materials, different glues are used, such as glass glue and all-purpose glue. Glass glue is glued by drawing a line from the middle of each stroke of a word, and small strokes can be done without typing. Don't use too much glue to prevent it from overflowing from the edge of the word, which will affect the appearance. )
6. Tear off the hollowed-out photo film after the door head is attached. Each door head is attached to the door head with two pieces of adhesive tape, and the adhesive tape is torn off after the glass glue solidifies the next day.
The door is the face of a shop, and a good luminous character at the door is very attractive, but to design a beautiful luminous character door and a luminous character door with good quality and good effect during the day and night, in addition to the professional production team, there must be a professional design team and a professional installation team. From design to manufacture to installation, these three processes are very important.
The door is equipped with luminous characters:?
First installation: The usual luminous character consists of three parts: panel, bottom plate and sideband. The panel is glued directly, and the screws are not visible on the bottom plate. There are two ways:
The bottom plate is directly bonded to the sideband, which has the advantage of high efficiency. Disadvantages are unsightly and inconvenient maintenance.
Support points are made around the side band, and then tightened with screws, which is convenient for maintenance and high-grade in appearance. The disadvantage is that typing efficiency is lower than direct gluing. If you don't see the screws after installing the characters, just uncover the luminous character panel and put the screws in. If installed on a wooden board, use screws directly. If it is aluminum alloy, drill the hole with an electric drill first, and then install it with rivets.
The second installation: how to install the acrylic luminous characters wrapped in metal at the door head? How is the electricity connected? Do you want to pull the electricity in the store to the words on the door? Is that line ugly? Fix the luminous word on the card surface with double-sided adhesive, coat it with glass glue, and connect the wire through the card surface to the transformer, and it will be OK. Fix the acrylic characters on the back board with the express line, and then apply glass glue around the acrylic characters. The LED light source is 12V, so you need a 12V transformer connected to the acrylic word. The wire can be installed behind the backward movement.