Expansion: Kamen Rider is a Japanese series with more than 30 knights, so there are many kinds of Kamen Rider belts. Make one for the children now.
Tools/raw materials
A large piece of cardboard
a pair of scissors
A compass
Take a ruler.
A black marker and a gold marker.
Methods/steps
1
First, draw a perfect circle on the cardboard with a compass.
2
Then draw two perfect circles with the same center.
three
Draw two lines at the same position on both sides of the circle.
four
Connect two sides with the outside of the largest circle.
five
Draw a big hand on the circle.
six
Draw four more lines horizontally, as shown below.
seven
Draw small squares in the upper and lower rooms of the four lines with a ruler.
eight
Draw the outline of a big hand with a golden pen.
nine
Paint the big hand and the small triangle in the picture black with a black pen.
10
Draw patterns on both sides of the big hand.
1 1
Draw a thin circle in the pattern. Colour all the blanks gray.
12
Stretch the middle of this belt to both sides with a ruler.
13
The extended edges are painted black.
14
Deepen the edge of the belt with black.
15
At both ends of the extension, cut a hole upward from one end.
16
Cut a hole with the other end facing down.
17
Cross the ends together. No, the joints are inside.
18
Fold the edge of the big circle where the right hand is located. Fold the second vertical line outward and the third vertical line next to it inward.
19
Fold the left side three times in the same way. A three-dimensional Kamen Rider belt is ready.
end
Matters needing attention
When drawing circles and straight lines, tools such as compasses and rulers must be used to make them more standardized.
Cardboard should be made of large materials and thicker, so that it can be strong and strong to wear.