Illustrations of fishing drift adjustment techniques are as follows:

1. Roughly find the bottom

Without hanging sub-lines, heavy lead is hung on the lead skin base, and the weight of the lead skin is greater than With the buoyancy of the float, all the floats are submerged in the water. Gradually pull up the float until it is visible. The top space bean is next to the second space bean. Complete the positioning. Remember that the top space bean should not be used again until the end of this fishing. Go and touch it.

2. Adjust the mesh

Pull the float down and throw it into the water until the float is completely submerged in the water. Gradually cut the lead skin until the required mesh number is exposed, which is the mesh adjustment.

3. Basic principles of mesh adjustment and fishing mesh setting

7 mesh soft tail floating bait: adjust 4-5 to fish 2; 7 mesh soft tail floating bait: adjust 3 -4 to catch 2; hard thin tail rubbing bait: adjust 7-9 mesh, catch 2-3 mesh

Hard thin tail pulling bait: adjust 5-7 mesh, catch 2-3 mesh; fishing mesh is high , the fishing is blunt; the fishing eyes are low, and the fishing is clever. Fine-tune the above adjustments according to the weather, season, hook weight, bait specific gravity and bait ball size.

4. Find the bottom accurately

Hang up the sub-line, move the float, and adjust the distance between the position of the float seat and the positioned upper space bean to be roughly equal to the length of the sub-line. , rub the bait under the lower hook and hang a large bait ball to find the bottom (also to make a nest), so that the float is 2 mesh above the water surface, and continue to pull the float up for 2 centimeters.

If the float displays more than 3 mesh, it means it has passed the bottom. Pull the float back 2 centimeters. This action is called reverse bottom search. Then hang a bait ball of normal fishing size and throw the rod into the water, and fine-tune it. Float until the fishing mesh is about 2 mesh and conduct trial fishing.

5. Trial fishing adjustment process

(1) There is a mouth but no fish: fishing is too good, pull up the float 2CM (can be pulled up continuously within 5 times), and continuously hit the upper lip Fish found more than 2 times means it has found the right mouth.

(2) The fish caught is on the edge of the mouth or on the lower jaw. This means the fishing is too blunt. Pull the float up 1 cm each time. If the fish hits the upper lip more than twice, the right mouth is found.

(3) Fishing at the bottom without a mouth: Pull down the float 15 centimeters each time to find the water layer where the fish is. This falls into the category of fishing off the bottom - fishing for the float - fishing for one mark depth, which will be discussed separately. Of.