1. Maintenance of Jiuyang Soymilk Machine
1. If there is no response after the soymilk machine is powered on, we should first check the power cord to see if there is any problem. We can take the machine apart and measure it with a multimeter to see if there is a short circuit or an open circuit. If it is well connected, we can rule out the problem of the power cord.
2. Use a meter to measure the fuse tube of the circuit board (the component covered with black sleeve on the board) to see if there is any fuse phenomenon. If there is a fuse, it means that there are traces of fire in the plastic part of the machine. This is caused by the burning of the circuit and the spark from the internal combustion of the motor.
3. Next, we need to remove the motor and look at the degree of internal damage. If the circuit board is damaged in a large area and the motor is burned, it should be caused by water entering the nose during improper cleaning.
4. In this case, the maintenance is very complicated. Only by replacing the main engine and motor can the soymilk machine return to normal operation. The back of the main board is full of small patch components and chips, which is relatively more time-consuming and labor-intensive. Therefore, the soymilk machine must not be placed directly under the faucet for cleaning, which is very likely to cause damage to the internal circuit due to water ingress.
2. How to use Jiuyang Soymilk Machine correctly?
1. Soak the beans, so that they won't be too hard after soaking, which makes it easier to extract soybean milk. Use a soymilk machine with a measuring cup for dried beans to take out dried beans according to 2/3 scale lines, and then soak them in clean water for 8-16 hours in spring and autumn, 6-1 hours in summer and 1-16 hours in winter. If you want to speed up the soaking time, you can choose warm water to soak properly, which can shorten it to 2 to 3 hours. But it is more appropriate to follow the general practice.
2. Add beans and rice to the cup, and use it to measure rice in a bean measuring cup according to the scale of 2/3, and then wash it with soaked beans and put it directly into the cup.
3. When water is added into the cup, there will be a water level line in the cup. Add water between the upper and lower water lines.
4. For the installation of Raphael net or grain refiner, take Raphael net and install it in the direction of the arrow indicating the installation of grain refiner. The joint between Raphael net mouth and machine head should be tight and seamless. After installation, pull it down by hand, and the Raphael net will not move, indicating that it is in place.
5. To make soybean milk, put the machine head into the cup according to the correct position, plug in the power cord, and the power indicator light will be on. Press the soybean milk button, and the corresponding indicator light will be on, so as to start the whole nutrition soybean milk program. When the soybean milk is ready, there will be a prompt light or a prompt sound, and then the soybean milk is ready.
6. After pulping is completed, the machine performs multiple pulping and full boiling according to the set procedure, the electric heater and motor stop working, and the machine gives an audible and visual alarm to indicate that the soybean milk is ready. Unplug the power plug and you are ready to drink.
7. Filter soybean milk (only for dry bean/wet bean soybean milk). When making dry bean/wet bean soybean milk, the pulp and residue are boiled together, so that the nutrition is released more fully. Users can filter the soybean milk according to their own preferences, which can make the taste more delicate.
This is the end of the introduction of the maintenance of Jiuyang Soymilk Machine. I believe you will have a certain understanding of the maintenance of Jiuyang Soymilk Machine through the above contents. You can refer to the above contents when carrying out maintenance, and of course you need to pay attention to safety.