Current location - Recipe Complete Network - Complete recipe book - The right way to adjust the drift for fishing
The right way to adjust the drift for fishing

Methods are as follows:

1, first of all, in the lead seat on the roll of lead, the lead must be wrapped tightly. If you don't, the lead will come loose when you are fishing.

2, in the drift seat on the fish after the drift into the water, as shown in the picture of the weight of the lead to make the drift sink into the water, this is because the buoyancy of the drift is now less than the weight of the lead to this old excitement. After the drift sinks into the water, move the drift upward to make the water wait for the swift line to grow, until the drift is exposed to the surface of the water for two eyes. This will allow you to measure the depth of the water, from the drift below two eyes until the end of the fishing line connected to the end of the lead skin seat how long the distance, how deep the water is. This will allow you to measure the depth of the water.

3, measured the depth of the water can be adjusted after the drift, the distance between the drift and the lead seat adjusted to half the depth of the water, and then put the lead into the water when the drift sinks into the water again.

4, then you can use scissors to cut off the lead on the lead seat a little bit, pay attention to not cut too much at a time. Every time you cut off a little bit of lead, the weight of the lead will be reduced a little bit, with the weight of the lead slowly reduced, when the weight of the lead is less than the buoyancy of the drift will slowly float out of the water.

5, let the float out of the water 4 eyes can be, if the number of eyes floating out of the water more than 4 eyes and then in the lead on the seat to increase the lead, let the drift down to the water only 4 eyes until.

6, and then hang on to the fish hook on the food, into the water at this time the drift and sink into the water. This is because the weight of the lead and the food is greater than the buoyancy of the drift. At this time, you just need to adjust the drift upward until the surface of the water 3 eyes, more than 3 eyes downward until the surface of the water 3 eyes.