1. Look for the bottom with heavy lead.

First find a piece of heavy lead, that is, a lead sheet with greater buoyancy than the whole, and then roll the lead, trying to roll it as tightly as possible without leaving any air. If there is a lead sheet, use it. Since we don’t know the water depth now, we just set the float at a random position, then throw the rod into your fishing point, press the water line down, and after checking the position of the float at this time, pull out the float and pull down or push up the float position until Adjust the floating tip to a little above the water surface, preferably no more than 1 mesh.

2. Pull down the float.

Some fishing friends asked, if my fishing point is far away and the exposed floating tip cannot exceed 1 eye, how can I see it? We also need one more tool here, which is polarized sunglasses, preferably for fishing. You will find that you can see clearly even the distant float. When the floating tip just shows its head, the distance from the floating tip to the lead pendant is the water depth. Then we pull the lead seat down to a distance much greater than the length of the sub-line, leaving a space bean in its original position as a water depth mark.

3. Find the right tune.

Since the float is very downward at this time, you can never see the float after entering the water, so at this time we start to cut the lead to allow the float to float up. After several times of casting and cutting, we will see The float shows its head, and then carefully pulls down or pushes up to reveal the desired adjustment. We should also pay attention when setting the adjusting mesh. If the target fish is big, the adjusting mesh should be large, and vice versa.

4. Find the correct fishing target.

After adjusting the fishing target, let’s start setting the fishing target. In this step, we need to find the bottom more carefully, so first hang the bait. Try not to use plasticine or small lead sheets. After all, the weight of these things is different from the real bait (the bait will atomize and lose weight when it enters the water), and then It is to repeatedly throw the rod and push up the float several times until the number of meshes the float emerges from the water is the number of fishing meshes you need. At this point, you can start fishing.