Improper use leads to water in the machine, so that the computer board is partially short-circuited.1, vibration at work, noise: too little water or too many beans. Soybean milk mesh blockage. Motor bearing wear. Motor carbon brush wear. Motor or other parts of the screws loose. 2, the work is not completed, fault alarm: pulp machine has not been completely finished, so the alarm. 3, soybean milk overflow: the surface of the anti-overflow needle has not been cleaned to get the signal. Relay can not be reset after suction, the heat pipe has been heating.

First, the work of vibration, noise

We use soybean milk machine to squeeze soybean milk, will always find soybean milk machine work very loud, indicating that there are some problems with soybean milk machine, so we have to find out the reason for the soybean milk machine vibration, noise. The reasons analyzed may be too little water or too many beans; soybean milk mesh blockage; motor bearing wear; motor carbon brush wear; motor or other parts of the screws loose.

Second, the work is not completed, fault alarm

If the soybean milk machine in use, the work is not completed alarm, explains the soybean milk machine has not been completely finished work, so the alarm. Soybean milk machine does not turn the reason may be: improper use leads to water in the machine, so that the computer board local short circuit.

Third, soybean milk overflow

anti-spill needle surface is not clean, can not get the signal; relay can not be reset after the suction, the heat pipe has been heated; diode breakdown, boiling full-power heating; computer board moisture, the chip program confusion; improper use of the machine leads to water, so that the computer board local short circuit; anti-spill needle inserted by the signal terminals loose; double-plugged power cord failure (bottom-heating type). The two-plug power cord failure (bottom-heating type soybean milk machine).