Flip hook refers to a kind of hook that keeps the bait and hook in an upward posture with the help of the gravity of the lead drop after entering the water. Because the bait and hook will turn over in water, this hook is called "turning hook" figuratively. At the moment of throwing it into the water, it has been entangled in many hooks.

Flip fishing originated in Hunan, and locals like to use 4-hook duplicate hooks, with 3 hooks as the most, especially now that the temperature is rising. In summer, the small fish made a terrible nest, and many people found that it was no different from fishing with 4 hooks or 6 hooks. Whether the bell rings or not, the little fish should still go up.

There are not many hooks for fishing, and fish can catch fish with 4 to 6 hooks. Once the fish are lured into the nest and find the cake bait, they will circle around the cake and eat it. The slow atomization of bran cake caused the hunger effect, and the eating process would not end until the fish took the bait. This is the genius and greatness of using the constantly atomized cake bait as the bait for turning over the plate.

Use of turnover hook:

The bait of the flip hook can be flour bait made of corn flour and tofu powder, or bean cake, which is sticky and not easy to foam. The somersault hook can be thrown into the fishing spot by hand, and it is not recommended to throw it with the "turntable". After the hook touches the bottom, gently tighten the main line and flip the hook, which belongs to a common fishing gear for bottom fishing and adopts "mother-child bait".

When fishing with a hook, the fish are attracted by the bait, but they can't reach it. At this time, the fish on the greedy insects have no choice but to eat bait. So in the case of fish, the fishing speed is faster. If it is used to catch big carp, the effect is better. Prepare an iron plate (or lead plate) with a diameter of about 8 cm and a thickness of about 2 mm and a plexiglass plate.

Drill a small hole in the middle, and then drill seven or eight holes along the edge of the iron plate, which should be evenly distributed to facilitate hooking. Then use a small screw with a slightly thick middle and threads at both ends, put it in from the small east in the middle, put the two plates at both ends, and tighten the hoops with small nuts outside. The distance between the two fixing plates is about 2 cm, and the main line is tied to the exposed screws on the plexiglass plate.