I. The working principle of the germinator/germinator: Provide the seeds to absorb enough moisture to germinate, maintain the appropriate temperature to make the seeds germinate, through the germination device can greatly improve the germination rate and shorten the germination time. Second, the germinator/germinator model parameters:

Purpose selection

Model

Power and voltage

Plastic bucket or tank

Reference water (L)

Rice seed casting

Sprouting special

YBQ-SC300

1500W/ 220V

Φ0.7×0.7m

200L (250px of water is suitable for submerging the seeds)

300kg (kilograms)

Sprouting/rice seed general purpose

YBQ-SC600

3000W/220V

Φ1.5×0.8m

1500-1800L (water is suitable for submerging the seeds)

Sprouting/rice seed general purpose

YBQ-SC600

3000W/220V

Φ1.5×0.8m

<

1500-1800L (250px for seeds)

600kg (kilograms)

For rice seeds

YBQ-SC1000

3500W/220V

Φ1.5×1.3m

2600L (250px for seeds)

YBQ-SC1000

3000W/220V

3000W/220V

3000W/220V

Φ1.5×1.3m

2600L (250px for seeds) )

1000kg (kilograms)

Two, the advantages of the germinator/germinator:

1, can be carried out through the microcomputer to control the time and temperature of the water in the container (timed, set the temperature), the water required for the seed to monitor the temperature in real time.

2, the operation method is simple, the use of the environment is not too restrictive: the germinator/germinator does not require a special germination environment and specific containers, in the household power supply 220V can be carried out under the normal work of the germinator/germinator.

3, fast germination: set the temperature 32 ° C constant temperature, oxygenation, in 48 hours (two days) can be sprouted.

4, high efficiency, can be reused: the germinator 2 days to germinate, can be repeated many times.

Three, the use of the germinator / catalyst:

1, the heating assembly placed in the center of the bottom of the container, the isolation cover is fastened to the assembly.

2, put rice seeds/sprouting seeds/vegetable seeds/crop seeds (or other seeds) into the bag, and place up to 50-60 pounds of seeds in each bag, and yard them above the heating assembly.

3, the container length and width should not exceed 1.3 meters, if used outdoors, it is best to keep warm, after the seeds are placed neatly, add water not more than 10 centimeters above the seeds.

4, the host will be placed on a plane higher than the water surface, connected to the connecting line, be sure to plug tight.

5, connect the air tube and temperature control line, individual air tubes may be a little loose because of temperature problems, tighten with a wire at the root.

6, plug the main power supply, connect the main power plug board to choose more than 16A, the wire should be greater than 2.5 square, to avoid excessive power line heating fire.

7, turn on the power, open the oxygen pump switch, this time there will be bubbles in the container turned up, uniform and tumbling.

8, press the control handle of the heating switch to energize the heating rod. The heating rod is 3000w/1500w, if it trips, please replace the power supply line.

9, press the heating switch, the heating lamp above the switch shows red, working as normal, due to the large amount of water in the container, the heating speed is slow, you can pre-injection of warm water.

10, germination began, 48 hours after the seeds will grow uniform small buds, if you pre-soak the seeds, the time may be shortened, please control the germination time according to the actual situation

Zhengzhou Yi Beiqi Agricultural Equipment Co.