First, heavy lead to find the bottom

Pack a piece of lead, enough to drag all the floating objects into the water. Pull the space bean toward the extreme tip until the float is exposed to 1-2 mesh. At this time, the distance from the lead base to the end of the float is the actual water depth.

Second, pull down the float.

Pull down the space bean in the direction of lead base (the distance between the sub-line and the floating tail is about 5 cm), and ensure that the distance from the lower hook to the floating tail is less than the actual water depth, which is semi-floating.

Third, trim the lead skin.

Trim the lead skin slightly until the float leaks out of the mesh (I usually adjust it to 4-6 meshes).

Fourth, hang up the double bait and pull up the float.

Hanging double bait, floating generally does not reach the water. Pull up the float until the tail of the float comes out of the water. If it was adjusted to 4 mesh before, it is more sensitive to catch 1-4 mesh now. Adjust it according to the situation of the fish.

The steps of bleaching are as follows:

Step 1: Find the bottom with heavy lead.

In this step, you must first ensure that the weight of your lead weight is greater than your buoyancy, and pull the float closer to the lead weight to ensure that the whole float can be pulled into the water. Then pull up the float, so that the float has one or two eyes above the water surface, then the distance from your float below the water surface to your lead pendant is your water depth at this time.

Step 2: Pull down the buoy.

When we find the right water depth, we will pull down the float at this time. The pull-down distance is preferably ten to twenty centimeters longer than the length of the sub-line. Actually, to put it bluntly, semi-Shui Piao is called bottom drift. After adjusting the drift, make sure that the double hook is separated from the bottom. So the pull-down length must be greater than the length of the sub-line.

Step 3: Trim the lead skin to find the tone.

Trimming lead and peeling can generally be divided into rough shear, fine shear and fine shear. Rough cutting is based on the speed at which you float and turn over and sink into the water. If you enter the water quickly, it means that your weight is much greater than buoyancy. You can cut more at this time. But when you float, flip and sink slowly, then we have to cut carefully and cut less.

Step 4: Rub the bait to find the bottom and find the fisheye.

At this time, we will rub two baits to find the bottom. At this time, we will pull the float into the water, and then we will pull the float up until we show our eyes that we want to fish, and then we can start fishing. In fact, in the last step, we want to know clearly the specific state of the hook bait underwater, so it is best to measure your hook weight and bait weight.

Then, before adjusting the drift, you must consider the proportion of bait you use and choose the appropriate drift according to the proportion of bait. I need to adjust a few catches specifically. This is the four-step bleaching method, and the steps will be fine, but the details must be paid attention to, and often the details determine success or failure.

In short, there are too many things to pay attention to in drifting, such as the proportion of bait, the thickness of tail and the speed of fish mouth. According to the constant change of fish mouth, it is most important to find the right fish mouth and use fishing method flexibly.