1. Place the equipment upright and the machine body is on the ground smoothly.

2. Ground the power cord as required. Use AC380V power supply.

3. Clean the inside of the furnace body, remove the protective film on the outer surface, close the drain valve, open the oil inlet valve, and let the furnace water until the oil drain valve overflows. Turn off the oil drain valve and add edible frying oil (note: oil that produces a lot of foam after being heated cannot be added). The oil level should be at least 80mm higher than the heating pipe. Different models of frying machines should add water and oil at one time.

4. Install the oil drainer on the left or right side of the furnace body (facing the control panel). It is strictly prohibited to place the oil drainer on the air guide seat.