2. Cut the four corners into rounded corners, and polish the edges with an edge trimmer, and compare the dimensions.
3. Moisten the skin with warm water. Under normal circumstances, it should be soaked in warm water for more than ten seconds, and then wipe off the excess water on the surface with a paper towel.
4. Put the slightly dry leather on the back of the mobile phone with the back shell and position it correctly.
It should be molded with rubber roller and fingers. I only have a broken agate knife in hand, and it works well after trying it.
6. The molding is almost complete. When the leather dries quickly, it will be molded again to avoid springback.
7. Make a few round holes in the sound hole on the back of the phone, and the camera and flash are in this position. Punch four round holes in four corners with a round punch, and then cut four sides with a knife.
8. All corners are polished with good edge sealing liquid, and the specific edge sealing steps will not be described in detail.
9. After the edge sealing is completed, apply the hardener to the meat surface. The process here is not described in detail. I mix some water with tattoo pigment, and then use paper towels to rub the color with pigment. The correct way is to use cotton cloth dipped in alcohol dye to rub the color, and it is easy to rub off the dirty skin after other pigments are rubbed up.
10, use the printing tool to break some textures, then polish the horse and stick the leather and the back shell together with AB glue.