According to the zero degree of decoration network information, Philips juicer installation card tighten a little step is as follows:

1. Fixed host, according to the counterclockwise direction of the locking knob, the suction cups and countertops suction.

2. The bottom of the cylinder buckle into the host slot, push forward until you can hear the "click" sound, which means that the top.

3. Escape the pop-up ring into the root of the screw extruder.

4. Put the assembled screw extruder into the barrel.

5. Press the sealing ring into the bottom of the juice head nut and make sure that it has been flattened, if it is not flattened it may lead to air leakage and that is not good.

6. Turn the juice head and barrel counterclockwise to tighten.

7. Install the rocker, manual juicer, no rocker is equivalent to a car without a key, so be sure to install correctly.

8. Put in the pusher bar, the installation is complete, so you can start using the juice.