1, wear plastic film
(1) To get the film, you need to confirm the winding direction of the film, find the counterclockwise direction, clamp it with a circular splint and fix it on the film shaft. (Please turn off the power when pasting the film)
(2) Pay attention to whether the fixing splint before and after the film is closely combined with the film. If it can't be tightly combined, cut the inner side of the paper tube obliquely with a utility knife before putting it into the film paper tube.
(3) After pasting the adhesive film, firmly paste the adhesive film on the delivery tube with adhesive tape.
2, sealing operation steps (panel operation instructions)
(1) Turn on the power supply, turn on the power switch, and the indicator light will be on. Set the thermostat to a predetermined temperature, and the green heating indicator will light up. After the hot plate reaches the predetermined temperature, the red constant temperature indicator lights up (when the sealing machine works, the electric heating device alternates between heating and heat preservation, so the green and red indicator lights alternate constantly, which is a normal phenomenon).
(2) Put the plastic cup into the lower die slide plate, push the lower die slide plate to a certain position by hand, press the handle of the sealing machine to the maximum stroke, hold the pressure for 1 ~ 2 seconds, and then slowly lift the handle and push it back to its original position.
(3) Pull out the lower die slide plate, take out the plastic cup, put it into the unsealed plastic cup, and make another cycle. 、
Second, the cup sealing machine use matters needing attention
1. Connect the wires to ensure the safety of electricity use.
2. When the machine fails, turn off the power supply first, and then troubleshoot after the temperature returns to normal.
3. Don't put your hand between the upper die and the lower die during use, so as to avoid squeezing or scalding.
4. Before the handle is completely pressed down, the upper and lower dies must be aligned.
5. Don't push the handle too hard.
6. Keep the working voltage at 220 ~ 250 volts.
Three. Cleaning and maintenance of milk tea sealing machine
1. Regularly clean the machine surface, bottom plate, lower die slide plate, groove, heating platen and bumper in upper die (note: the power supply must be turned off to restore the normal temperature).
2. Regularly lubricate the sliding plate of the lower die, the bearing of the pressure bar, the eccentric wheel, the guide post, the guide rail and other rotating parts to ensure the performance of the machine.
3. Cleaning the toothed cutter: pour boiling water into the groove of the lower die until it is full, then push the lower template into place, press the upper die down to the lowest point, and let the toothed cutter soak for a few minutes until it is clean. Repeat it several times.
4. Common faults and solutions of sealing machine
1, the cup mouth is not tightly sealed and leaks.
(1) Foreign matter stuck on the pressure plate in the mold: Turn off the power supply and wipe it clean after the pressure plate in the upper mold returns to normal temperature.
(2) film wrinkling: adjust the film to make it flat and elastic.
(3) There is foreign body in the cup mouth: wipe the cup mouth clean before sealing.
(4) Insufficient or excessive temperature: adjust the temperature.
2. The plastic film cut at the mouth of the cup is not smooth or continuous.
(1) The gear cutter sticks bran slurry: clean the gear cutter.
(2) If the gear cutter is curled or damaged, please repair or replace it.