Current location - Recipe Complete Network - Healthy recipes - How to measure the water depth and adjust the drift when fishing
How to measure the water depth and adjust the drift when fishing

Methods are as follows:

1, first of all, in the lead seat on the roll of lead, the lead must be wrapped tightly. If you don't, the lead will come loose when you try to fish.

2, in the drift seat on the fish float into the water, as shown in the figure of the weight of the lead to make the drift sink into the water, this is because the buoyancy of the drift is now less than the weight of the lead. After the drift sinks into the water, move the drift upwards so that the water line grows until the drift is two meters above the water surface.

The depth of the water can then be measured by the length of the line from the bottom of the float to the end of the lead weight, and the depth of the water. This will allow you to measure the depth of the water.

3, measured the depth of the water can be adjusted after the drift, the distance between the drift and the lead seat adjusted to half the depth of the water, and then put into the water when the drift sinks into the water again.

4, then you can use scissors to cut off a little bit of lead on the lead seat, be careful not to cut too much at a time. Every time you cut off a little bit of lead, the weight of the lead will be reduced a little bit, with the weight of the lead slowly reduced, when the weight of the lead is less than the buoyancy of the drift will slowly float out of the water.

5, let the float out of the water 4 eyes can be, if the number of eyes floating out of the water more than 4 eyes and then in the lead on the seat to increase the lead, let the drift down to the water only 4 eyes until.

6, and then hang on to the fish hook on the food, into the water at this time the drift and sink into the water. This is because the weight of the lead and the food is greater than the buoyancy of the drift. At this point, you just need to adjust the drift upward until the surface of the water 3 eyes, more than 3 eyes downward until the surface of the water 3 eyes.

Expanded information:

The steps of adjusting the drift:

Without hanging double hooks, wrap the lead skin on the lead skin holder which is bigger than the buoyancy of the drift, and throw the line to the fishing point, at this time, the float should be completely submerged in the water. Then keep pushing up the float until it reveals the number of eyes, revealing the tip of the drift tail tip or about 1 eye can be, this is to find the bottom.

The bottom is an area, not a point, such as the diameter of 20-50cm range. You need to make a few more casts to probe the spot and make sure you find a relatively flat bottom (because it is impossible to cast to the same spot every time).

Another very important point is not to cast a full rod when finding the bottom. This is because when we are casting normally, the point where the lead falls is in front of the float. If you cast a full rod, the wind line will pull the float, the float can not keep up with the drop point of the lead, and thus the water line from the lead to the float is tilted, so the depth of the bottom you find is actually greater than the actual depth.

For example, if the actual depth of water is 2 meters, the depth of water from casting a full rod may be 2.5 meters, and if you use the depth of water from this time to hang up the subline to adjust the drift, it's very likely that the double hooks will not be completely off the bottom, so how can you adjust the drift right. The solution: do not throw the full rod or backward pumping rod a certain distance.