What are the common failures of electric hot pots and pans - repair electric hot pots and pans common failure methods
Electric hot pots and pans have become many families commonly used kitchen appliances, but, although the quality of electric hot pots and pans is reliable, but the use of time will produce a variety of failures. Below, I'll tell you about the common failures of electric hot pots and repair the common failures of electric hot pots, I hope to help you!
Lights do not light, not heating
Check whether the power cord is energized; check whether the fuse is energized; check whether there are other off or burned wires. Also if the light is not on and heating, then it is possible that the light is broken and you need to change the light board.
Leakage
This failure may be connected to the wrong line, heating plate heating tube leakage, water or moisture caused by, you can check against the other new pot, wiring, changing the plate, drying to solve, in addition to judging the use of power supply to determine whether there is a three-phase grounding line to solve. Note: Because electrical appliances have inductive power, do not use the electric pen on the 'light or not to determine whether the leakage.
Reasons for malfunctioning of the connection between the wire and the pot
Due to water ingress or prolonged back and forth insertion and removal is very easy to lead to too large a gap, resulting in ignition burned. So it is recommended that when this problem occurs, you should change the socket at the same time to change the wire, because if you continue to use the original wire, there is a risk of burning out again.
A burnt heating plate may be
Amoy rice or rice collision with the bottom of the pot gall bladder deformation after the early trip, and artificial strong heating caused by burnt plate.
1. long into the inter-overloaded use or water caused by the contacts can not be separated or the magnet is not flexible, suction, not a new magnet, and then according to the original line mounted on the heating plate, and at the same time use a multimeter to measure the fuse can be electricity, not a change in the fuse, the heating plate is installed, be sure to check the contacts can be normal points, close the open.
2. Electric burner burned out can sometimes be repaired by changing the new contacts. If the pot is not flat, put the pot in the pot has been replaced in the pan, with a leather hammer circle slowly beat the bottom of the pot, until the pot and the heating plate arc will match, so that the heating plate heat can be uniform, rapid transmission to the pot on the gallbladder, will not make the electric heating pot heating plate localized overheating and early tripping.
Sticky pot situation is also a common phenomenon of electric burner, it is generally caused by the following three reasons
1. pot body for a long time running, and in addition to the body of the pot into the water leading to the contacts can not be separated or magnets can not be popped up, resulting in the phenomenon of sticky pot. If this is the cause of the paste pot, it is recommended to change the contacts, or new magnets.
2. Magnet tripping temperature is not right, different sizes of pots and pans with the magnet tripping temperature is not the same. For example, 700W pot with 2500W pot magnet is easy to paste the pot. Approach: change the matching magnet.
3. Iron pots and pans due to heat transfer, heat dissipation and other reasons, it is easy to paste the pot, rust, out of the trachoma, it is best not to use the iron pots and pans look thick and heavy.
Lights on, not heating
The wires in the pot are connected wrong or off. Methods: reconnect the wire; press the heating button, the contact can not be closed. Methods: adjust the contact spacing; heating plate heating tube burned out, methods: change the new heating plate.
;