Zanthoxylum bungeanum has strong adaptability and is not difficult to manage. It can be planted in front of and behind the house. If the germination rate of Zanthoxylum bungeanum seeds is high, the most important thing is to treat the seeds, including the following steps: 1. Oil removal of autumn sowing seeds. Because there are many empty seeds in Zanthoxylum bungeanum seeds, before seed treatment, water should be divided, then the empty seeds should be removed, and then the pepper seeds with full particles should be degreased, that is, the seeds should be put into a water tank or an iron pot, scalded with boiling water for 4-5 minutes, and then cold water should be quickly added, and the temperature should be controlled at 30-40℃; 2. Rub the oil, that is, pour the seeds into 2% alkaline water or soak them in 1% washing powder water for 2 to 3 days, and constantly stir them with a stick during the soaking process to remove the oil on the surface; 3. Cleaning: Because the soaked seeds contain a lot of oil, it is necessary to clean them with clear water for many times until the surface of the seeds is black but dull, then take out the seeds and pile them up for 1 ~ 2 days before sowing. Before sowing, mix the seeds with plant ash and sprinkle with ash.

The processing of light pepper seeds is actually not that complicated. Don't rub the seeds with alkaline water in the sun after they are hatched. Take out the flat seeds floating on it and throw them away. Just air dry the full seeds below a little, and they won't stick to your hands. Just plant them in classified fields. Note that the seeds of Zanthoxylum bungeanum have a high germination rate as soon as they are shelled. The method to see if the seeds can germinate is also very simple: gently cut a Zanthoxylum bungeanum with a knife to see if the seeds are yellow, but the white ones will germinate.

Do a good job in field management after emergence in the coming year. Fertilization should be applied in rainy days in mountainous areas without irrigation conditions. Don't apply too much chemical fertilizer to avoid burning seedlings. Plant in autumn or the following spring, and stand the pole about 50 cm from the ground after survival.

Zanthoxylum bungeanum seeds have high germination rate and rapid emergence. The key is seed treatment, and the seeds are covered with oil protective layer, which affects germination and emergence. Therefore, degreasing treatment must be carried out before sowing. The method of degreasing is: there are more empty seeds of Zanthoxylum bungeanum, accounting for more than 50%. Before treatment, empty seeds should be washed with water, and full seeds should be degreased. When degreasing, 200g of washing powder should be dissolved in warm water, then 50kg of decanting water should be stirred evenly and poured into a water tank or a small basin, and the water temperature should be 50 ~ 60 degrees. Secondly, pour the treated seeds into the washing powder solution and rub them repeatedly with a wooden handle until the bright color of the seed coat turns brown. Finally, this solution has a high viscosity because it is mixed with friction oil. After rubbing, soak it in clear water for 6 ~ 10 hour to soften the seed coat, then rinse it repeatedly with clear water until the seed coat is oily, and then take it out and dry it to sow.