1, spread out the paper towel, lay it flat on the table, and fold it about 3-4cm short. Depending on the size of your paper towel, I use a smaller paper towel, so it only needs 3cm. It will look better if you fold it with a large paper towel.

2. Similarly, select a length of about 4cm from the other section and roll it up until it is all rolled up. Select the upper part of the rolled paper towel (that is, the end you folded in the first step) as the petal of the rose, pinch it as shown in the figure and spiral it downward.

3. After the spiral is about the same length, we will start to make leaves, and the small corner at the lower end of the paper towel will be folded up. Take a section with a small corner and don't need to stick it on the spiral part, then continue to spiral the redundant part downwards and slightly tidy the petals of the rose, so that a beautiful rose is ready.

Second, the second method:

1. First, fold the square paper in half vertically and horizontally. At this time, the left bottom corner of the square in the lower left corner is folded obliquely. The remaining four corners are folded in the same way. Flip the origami model when finished. Fold the right bottom corner diagonally to the left along the crease. The other side operates in the same way.

2. Flip the origami model. Fold the origami model in half. After all the folding is completed, unfold the origami model and rotate it by 90 degrees, and then fold it again according to the previous steps. Take the middle point where the crease passes and make a horizontal crease. After the folding is completed, restore the folding. Rotate 90 degrees and then perform the same folding operation as before.