The decoration industry has two busy months of the year. One is around summer vacation and the other is around Chinese New Year, because office workers work all year round and only these two periods have holidays, maybe because of home renovation projects. They usually choose to install plastic gussets during these two periods. The installation method of plastic ceilings is generally suitable for old houses in the northwest. The installation project of plastic roof is relatively large. Whether it is a new house or an old house, you need to be familiar with the method of installing plastic roof. The following is an introduction to the installation method of plastic gusset plates.

The steps that plastic gussets generally go through during the decoration process: the ink lines must be played, and then the keels must be installed according to the lines. After installation, the booms are installed, then the edge keels are installed, and finally Install the fastening plate of the plastic gusset plate, clean up the site and other steps.

Plastic ceiling installation preparation: Before installing the plastic gusset ceiling, check the condition of the plastic gusset ceiling and check the parts or accessories. If there are no problems, prepare the installation kit.

First use a soft ruler to measure the required data, try to measure as accurately as possible, reduce errors, and organize the data; plan the installation location and corresponding height of the ceiling; the installation height of the ceiling should not be too low. If it is installed low, it will give people a depressing feeling.

After determining the installation height of the plastic gusset plate, you can use ink lines to mark the height of the elastic line on the surrounding walls. The baseline should be clearly marked to minimize errors.

In terms of plastic ceiling installation specifications, attention should be paid to the specifications and styles of the ceiling. First, we must look at the style of the interior decoration, as well as the indoor area, light source and other issues to determine the actual height and width of the plastic gussets.

Determine the keel position line for the plastic gusset plate installation: the keel positioning line is used to support the shape of the exterior decorative material and fix its structure. On the basis of determining the height and width data of the plastic gusset plate, we strive to fully meet the standards during the installation process.

The structural size and position line of the keel can be determined according to the panel specifications, and the determined position line can be marked on the top of the baseline to reduce errors during the installation process. When installing the main keel suspension plate, please pay attention to the spacing of the suspenders. If you are not sure, you can ask the store first. The middle section should be arched. The height of the keel arch should be 1/200 of the cross-sectional span of the room.

After the main keel of the plastic gusset plate is installed, first compare the position and height. If there is a problem, it can be repaired in time. Then continue to install, some curved zigzag single keels, make slight adjustments, remember not to be close to the entrance and exit of the lighting circuit.

When installing the boom with plastic gusset plates, it should be in a vertical position and the load-bearing capacity must be qualified. The boom is the first line of anti-rust. It is located at the end of the main keel and should not exceed 300mm. Otherwise, the boom must be enlarged. If a boom is added, it is best to use adhesive welding to avoid causing the main keel to fall due to force. Plastic ceiling panel edge joist installation.

The curved keel should be installed close to the main keel, and the levelness and firmness of the keel should be checked after installation. Fasteners are connected parallel to the keel. Please use special joints to connect. When installing the last board, cut it with a cutting knife according to the final actual size, gently bend the panel and load it, and finally seal it with wooden strips. The above is the content of plastic gusset installation.

Tubatu provides you with "each decoration quotation, 1-4 local decoration companies, 3 sets of decoration design plans" online for free, as well as decoration avoidance strategies! Click this link:/yezhu/zxbj-cszy.php?to8to_from=seo_zhidao_m_jiare&wb, and you can get it for free~