Current location - Recipe Complete Network - Complete vegetarian recipes - Use of installation nozzle
Use of installation nozzle
tip 16

Paper pasting nozzle:No. 16

Medium consistency

90 degree angle

The flower nozzle can't touch the cake surface.

Steps: Extrusion-Force-Lift

Note: if the decoration area is large, such as the little star I made last time, you can use tip20 10, which is a flower shape of three stars together, which is very labor-saving.

It took me three hours to make that bear last time. With this estimate, the time is at least halved.

The following are two other uses of tip 16:

Note: please pay attention to the logo in the upper left corner of the small picture. The inclined white triangular flower mouth forms a 45-degree angle with the cake surface;

The small white circle represents a straight line from left to right (right handed) and a straight line from right to left (left handed).

Practice more, the key is to squeeze strength and force in time, and you can squeeze out beautiful stars.

Don't shake hands, or the stars will become crooked.

tip3

Decorative nozzle: No.3

Dilute viscosity

45 degree angle

The starting point and ending point of the flower nozzle contact the surface of the cake, and the middle part should be squeezed with it.

Steps: Squeeze from the starting point-squeeze by hand-finish at the end.

Note: printing is easier to do, just squeeze a pen slowly.

Grass is difficult, everyone should practice more ~

Use the installation nozzle No.2 1 to make the shell.

The angle between the cake surface and the decorating opening: 45 degrees.

Looking down, the hand position is 6 o'clock.

Steps: start from the middle of the shell-squeeze-slightly lift-pull-trim (collect the sharp tail)

On the rectangular cake in the picture below, the white shell flower is tip2 1, and the chocolate baker flower is tip 16.

Be a villain with tip2 1

Text:

Angle: 90 degrees

Step: Squeeze hard-just reach the diameter and width you want.

Feet and hands:

The angle is 30 degrees, and the pointer is at 6 o'clock.

Make shoes, hands, buttons, dots and so on with tip3.

After extruding the feet and hands with tip3, wait for 10 minutes, and then gently press the surface with your hands to set the shape.

Note: remember to pack the flowers in a bag to satisfy enough icing when you are a villain. If it is not enough, it needs to be supplemented, and the color will not be colored.