What are the reasons for powder fall after slitting machine slitting
What are the reasons for the powder falling after slitting of the dividing machine? Let me explain it for you next. Aluminum foil after processing is a vital part of an enterprise, related to an aluminum enterprise finished product rate and enterprise profit point. The higher the yield, the greater the profit point of the enterprise. Of course, the yield is every link to control, standardized operation, but also need excellent equipment and responsible leadership, staff. Equipment and operating standards I do not understand, do not dare to point fingers, I can only cut the knife according to practice to analyze. Here I talk about why the slitting will produce warped edges, multilateral, powder. Warp, polygonal, powder problems in addition to the material itself and equipment problems, most of which are related to the blade. Usually aluminum foil slitting mainly has two kinds of blades. One is a circular blade, one is a slice blade, also known as razor. One is a circular blade, a piece of rowing blade also known as razor. Razor blade is fixed a point position, to material winding passive cutting, scratching. Aluminum foil for active slitting, the faster the speed, the blade resistance is relatively small. The slower with the opposite. The thickness of the blade corresponds to the resistance. The thicker the blade, the greater the resistance. The thinner the opposite. As the razor blade is cut fixed immobile, the blade and foil, thin material contact, the cut point is prone to fatigue heat, so after a period of time will be the blade is not sharp, the knife blunt will be torn phenomenon, the emergence of powder off the burrs is inevitable. Of course, these are also related to the slitting angle. Choosing a good razor blade is the first choice to solve these problems, and ceramic blades should be the first choice. If the above content is helpful, then please like to support it!