1 First, put the toe cap through the bottom two shoe holes from bottom to top.

2. Align the ends of shoelaces, and then insert them into the second row of shoe holes.

3. Before threading into the next row of shoe holes, cross the shoelaces, and then vertically thread them under the shoelaces on the other side.

4. When you get to the top hole, cross the two toe caps again, then pass under the vertical part, and finally tie them tightly.

This picture is provided by the registered user "Brand Knowledge", and the copyright statement is feedback.

How to Tie Adidas Coconut Shoelaces-Zip Method

1, the toe cap is put in from the bottom and then goes out from the bottom of each shoe hole.

2. Make a circle around the toe cap on the inner side of the vamp, then the two toe caps are staggered with each other, and then pass through the shoe holes in the next row from below.

3. Repeat the above steps until the toe cap reaches the top hole.

How to tie Adidas coconut shoelaces -KAWS method

1. Remove the shoelaces of Yeezy 350. Be careful not to be impatient and not to damage the shoes during disassembly.

2. Stuff shoelaces into shoes and wear them from the inside out. They are located in two shoelace holes on the inside of the top of toes. It is worth noting that after putting it on, you must keep the length of shoelaces coming out of the two holes the same, otherwise it will be very difficult to follow up.

3. In the next hole, insert the shoelace from the outside into the shoelace hole in the second row from the toe. Be careful not to close it too tightly, which will affect the appearance of the upper.

4. Wear the shoe strap from the inside out, and the hole is located outside the first row of the toe cap.

5. Insert the worn shoelace into the second row of inner shoelace holes from the toes. Such an "X" is completed.

6. At this time, make an "X" on the other side, and the steps are the same as above.

7. Next, put the shoelaces on both sides through the holes in the third row from the toe. At this time, it is necessary to check whether the shoelaces on both sides are the same length, otherwise it will affect the performance.

8. Thread the shoelaces on both sides through the shoelace holes on the inner side of the last row to form a big "X". Note that the last two rows of outer shoelace holes should not be occupied.

9. After the three "X" shapes are completed, the shoelace inside the shoe passes through the third exclusive shoelace hole from the toe.

10, the worn shoelaces are introduced into the shoes from the last remaining hole, but they are not directly inserted.

1 1. Next, wrap the extra shoelaces around the diagonal shoelaces several times. Insert a little extra toe cap from the outer shoelace hole in the third row of toe caps.