How to plant Anemarrhena seeds:

1. Garden site selection

The quality of the soil directly determines the amount of Anemarrhena yield, if the soil is very good , the growth environment is very good, so management will be much more convenient, and the output will also increase. Anemarrhena has very few soil requirements, but sandy soil, loess, clay, and sandy soil are also okay. Anemarrhena is cold-tolerant and is not afraid of low rainfall and waterlogging. The planting base requires gentle terrain and easy drainage. There is a lot of rain during the rainy season, and the rainwater must be drained immediately, otherwise the seedlings may die on a large scale. The key point of the nursery is to facilitate the drainage of accumulated water. The soil can be normalized and the sunlight time is sufficient.

2. Soil preparation

1. Deep plowing: Anemarrhena responds very quickly to nutrients. If the soil has sufficient nutrients, it will grow green and the plant will be strong. However, the soil in some fields is a nursery with general nutrition. Therefore, if you want to know how much the mother will produce, you must spread a sufficient amount of organic fertilizer before planting. Spread 660㎡2.5~7T of cow dung and pig dung. After spreading the fertilizer, turn it over Plow once and rake once, so that the soil and fertilizer are fully and evenly mixed together, so that there are no big soil eggs, which is convenient for planting and germination.

2. Make a border: In order to facilitate the maintenance and management of Anemarrhena anemarrhena from beginning to end, including irrigation, weed removal, and fertilizer spreading, it is recommended to make the land into a standard 1.5m wide border. Length 16~22m, actual situation depends on the plot of land.

3. Sowing

The particle size of Anemarrhena seeds is average, and the germination level is very good. Before planting, some appropriate germination methods can be done. Part of the process is honestly not complicated. Use clean water. Soak for a day, then take out the sour stems and you can make them. Planting should be moderately thick or shallow, and the thickness of the covering soil should not be more than 4 cm. Usually sowing in rows, choosing an environment with low wind, mix the Anemarrhena seeds into wet sand, and scatter them on the ground. After planting, you can cover it with soil manually or mechanically. After covering the soil, water it once, about 8 to 12 days. Can sprout.

4. Seedling management

There are relatively few maintenance tasks during the growth period of Anemarrhena, with few pests and good development. The most important matters are irrigation, weed removal, pest control and disease control. At the peak of Anemarrhena’s growth, a large amount of water and fertilizer is required. At this time, 40 kilograms of quick-acting fertilizer can be applied to 660 square meters. During the period of Anemarrhena’s fastest development, A sufficient amount of water is required. This time should refer to the weather conditions to determine the frequency and time of watering.