You can find a bridge, but it may also be blocked, so you should find more bridges. It is best to have netizens who have connected to TOR to build bridges for you.
The last time I connected to TOR, it was set to start randomly, so I don't have to bother to find the bridge every time. As long as you make sure to use the computer at least once a day and let TOR connect once a day, you can basically avoid the trouble of finding bridges frequently.
Starting with downloading the torbrowser installation package, this paper discusses how to install and set up the onion browser. First, right-click the downloaded installation package-extract it to torbrowser. Then enter the unzipped file directory and double-click torbrowser to install the exe file. Click OK. Browse and select the installation location, and then click Install. Then start the installation process. Click Finish and check Run torbroswerBundle. Then the tor network settings window will pop up. Click on the link-Next. Then it indicates that the tor network is being connected. It usually takes more than ten minutes. If it takes too long to connect to the tor network, cancel the connection and click Configure. Select whether this computer needs to access the Internet through a proxy, and then click No-Next. Whether ISP blocks or censors tor network. The choice is yes. Select meek-amazon as the transport type. Click the link. Then connect to the tor network, and after the connection is successful, you can surf the Internet anonymously.
There is something wrong with the network cable. If the network cable is not reflected when connecting multiple computers, it can be judged that there is something wrong with the network cable after replacing it. Half of the problems of network cable include short circuit caused by rusty crystal head, open circuit in the middle of network cable and bad pressure of crystal head. At this time, a line tester is needed to check the network cable.
How to use the line tester: Connect both ends of a network cable to the cable interface of the line tester respectively, check that the corresponding lamp flashes from 1 to 8 or 8 to 1 in turn, and then flash the first-class lamp once or twice (that is, the number of paths of the host where the network cable is located), and cycle back and forth.
If there is a problem with the whole network, you need to check whether there is a problem with the switch. Go to the computer room where the switch is located to check whether the switch has electricity. If there is electricity, check whether the trunk port light connected to the switch is normal. If it is not normal, find the uplink switch to check whether it is normal. The trunk ports of some switches are connected with transceivers. Please check whether the transceivers are normal.