Standardized construction technology of automobile film

First of all, check the condition of the car: check whether there are scratches, paint drops, dents, damages, etc. In the body, glass and interior, and remit the inspection results to the owner, and ask the owner to sign the inspection form.

Then, the vehicle cleaning: use a water gun to flush off the car body sediment evenly, foam the car body, use a professional cleaning agent to remove insect stains and dirt on the glass, dry the outside, blow off the water on the side seams, and clean the inner room. After cleaning, drive the car into the film workshop.

The next step is indoor dust removal: the workshop dedicated to dust-free car film should be kept clean and tidy on weekdays, and the items should be placed in an orderly manner. Before construction, start the air purification system for one minute to completely remove dust and particulate impurities in the air.

After that, we should make good preparations for construction: protect the instrument panel, steering wheel, gear area, rear platform, seats and other accessories with special protective covers and large towels. Remind the owner to take valuables with him, and keep the rest in the storage box, seal it and hand it over to the front desk for safekeeping. The surface mats and foot mats in the car, and the positions of all circuits and appliances need to be protected with tarpaulins. According to the fact that water can't flow to the lower part of the instrument panel, tightly plug the joint between the glass and the instrument panel with absorbent cloth.

The car should be punched and cut: the cut car glass diaphragm should be placed on the top of the car, the front and rear covers or the film cutting table at the corresponding position. Then clean the outside of the glass to remove the dirt on the glass surface.

Then hot air gun setting: connect the power cord and adjust the temperature of the hot air gun. According to the radian of glass, the difficulty of construction and the characteristics of technicians' construction, the hot air setting method is selected by ourselves. During work, be careful that the power cord does not scratch the paint surface of the car.

Next is the fine cutting of automobile glass diaphragm: trim the shaped automobile glass diaphragm into a car-attached state with a professional art knife.

Then stick the front car film, and the maximum distance from the edge to the ceramic shall not exceed 2MM. When cutting, the inclination angle between the blade and the glass should not be greater than 30 degrees. If the rearview mirror cannot be removed, a small slit with a width of less than 3 mm should be cut upward in the center of the rearview mirror to facilitate the adhesion of the safety film.

Then clean the glass: remove the label glue, oil stain and paint, and clean it thoroughly for many times and three times.

Finally, the vehicle is handed over and the owner is asked to accept it.

Precautions for pasting automobile film:

(1) After the construction is completed, stick the window instruction on the window button to prevent the owner from shaking the window.

Displacement or warping of the film.

(2) Remind car owners that they can't lift the glass for three days in summer and five days off. Do not clean the safety membrane with water for a week, and gently wipe the safety membrane with a clean towel when washing the car. /kloc-Do not use demisting line for heating within 0/5 days, so as to avoid the residual water in the diaphragm heating up to generate heat energy, which may lead to glass breakage. Do not stick suction cups or other accessories on the film for a week.

In addition, it is necessary to pay a customer return visit to understand the customer's situation and make clear the influence of automobile glass film on customer's life.

I suggest you visit the Master Studio when you have time. They have a professional dust-free laminating workshop and laminating technicians, which can be used as a reference!