first, hardware preparation

first, there is a main parallel port line behind the server-four secondary parallel ports are divided to connect the printer in the kitchen, and the secondary parallel ports are connected to the remote controller first

second, the remote controller is connected to the network cable (the other end of this network cable is used to connect the module, and the length of the network cable extends from the server to the module position, and then extends outward for backup, and the position of the network cable on the module, Clip the network cable in the module slot with a tangent knife)

3. Connect the network cable to the other end of the module (this network cable is generally one meter), and the network cable is connected to the remote printing controller

4. Connect the remote printing controller to the kitchen printer

2. Prepare the software

1. Install the catering printer service program, and run the printer service program after installation.

2. Add points. Fill in the name yourself as needed. Select the name of the Server as the phone number, generally server. The port starts from 2, and the server itself occupies the first port 1. Format setting and single cutting; Other kitchen printers are the same as the above settings

3. Enter Tianzixing catering software, menu management-kitchen printing management, and set the printing category in turn (the name should be consistent with the name of the printer service program. ), floor print settings, print menu settings, kitchen parameter settings.

The catering software I use is Tianzi Star. Kitchen printing and cashier at the bar can be done simultaneously and separately!