wallpaper is a very popular wall decoration material, and everyone will consider its decoration effect when choosing it. Because we don't understand the decoration, everyone doesn't know how to use it correctly. So what do you know about the wallpaper design? Let's take a look at the pictures of the decoration wallpaper effect and what are the precautions for the decoration wallpaper design?

design skills of decorating wallpaper

1. Wall treatment: scrape the impurities on the wall with a scraper, scrape the concave-convex wall flat, and fill the gaps with gypsum powder. If the wall is soft or has a powder layer and the latex paint is swept, the wallpaper basement membrane should be brushed first to make the wall firm so that the wallpaper will not fall off.

2. Cutting wallpaper: firstly, measure the height and width of the wall, and cut the floral wallpaper by 5 to 8 cm according to the height of the wall for online trimming. For floral wallpaper, the symmetry of the pattern should be considered, so the cutting length should be increased according to the situation, and it will usually be extended to 8 to 11 cm.

3. Glue coating: Apply glue coating on the back of the cut wallpaper, paying special attention to the surrounding edges to ensure the construction quality. Put the coated wallpaper on the glued side for 5-11 minutes (be careful not to apply external force to avoid creases in the wallpaper, especially non-woven fabrics), so that it can be posted after the glue is completely penetrated into the bottom of the paper. Brush several wallpaper at a time and post them in sequence.

4. Wallpaper construction: Generally, the first wallpaper is posted from top to bottom at the door or in the internal corner, and the wallpaper is gently scraped from top to bottom and from inside to outside with a scraper to squeeze out bubbles and excess glue, so that the wallpaper is flat and close to the wall.

5. Trimming and cleaning: Cut off the excess wallpaper at the upper and lower ends, with sharp edges to avoid burrs, and then completely wipe off the glue remaining on the wallpaper surface with a sponge dipped in water to avoid yellowing. After the wallpaper is dried, if bubbles are found on the surface, cut it with a knife, inject glue and flatten it to eliminate them.

design considerations for decorating wallpaper

1. When pasting wallpaper yourself, the first thing to do is to scrape the wall flat with a scraper, clean up the fallen wall skin, and then remove the dirt on the wall surface to keep it flat and clean. After the wall surface is cleaned and leveled, we need to evenly draw a ditch mark on the wall surface with a scraper, and the ditch mark can make the wallpaper agent quickly penetrate into the wall surface.

2. After the groove marks of the auxiliary wallpaper agent infiltration on the wall surface are fixed, you can start to apply wallpaper agent on the wall surface. When applying wallpaper agent, you should pay attention to it evenly. After the wallpaper agent is evenly applied to the wall, you need to wait before you can paste wallpaper on it. During this time, we can prepare wallpaper and cut it according to the actual size of the wall.

3. After the wallpaper is cut, you can start pasting it on the wall. When pasting wallpaper, we must pay attention to pasting it from the top to the bottom, so as to paste it layer by layer. Also pay attention to the corner of the place must be firmly affixed, there is no gap. It is inevitable that there will be bubbles when pasting wallpaper. If the bubbles are not eliminated in time, it will easily cause the wallpaper to fall off. We just need to puncture the wallpaper with bubbles with a needle and then flatten the wallpaper.

Wallpaper can often be seen in our daily life. When choosing wallpaper, everyone needs to know how to use it correctly. The above is what Xiaobian introduced for everyone, and that's the end.