Gas stove is also a kind of cooker that is often used. The fuel used in this kind of stove is usually canned gas, which can be replaced at any time and is more convenient to carry when going out for a barbecue.

The difference between gas stove and gas stove;

Gas stoves belong to gas stoves, but there are some differences between them in structure. When using a gas stove, there is no need to equip a fuel vaporizing device and a fuel pressurizing mechanism. And no preheating is required. The oil tank is directly equipped with a control valve and an internal combustion engine, which can be used by opening the control valve and igniting, while the gas stove adjusts the natural gas to enter the burner through the knob, and ignites after mixing with air.

How to use the gas stove:

1. Make sure that the control valve is closed, tear off all labels attached to the gas tank, and then carry out assembly work. When assembling, the furnace should be kept upright.

2. Let the bottom of the burner face the top of the gas tank, hold the burner by hand and screw it into the gas tank gently until the flat pad and O-ring below the burner are closely connected with the gas tank. Be careful not to tighten it too tightly, so as not to damage the self-sealing safety valve (check needle valve) of the gas tank.

3. If you suspect, hear or smell gas leakage, you can't start the ignition. At this time, soapy water can be applied to the joints and joints for inspection (remember not to use fire to check air leakage). You can try to tighten the burner and gas tank a little. If it still leaks, stop using it and send it to repair.

4. After the gas tank is installed, pull open the support arm (stove rack) and put the stove on a stable plane to start ignition. The output firepower is regulated by the control valve. Using stabilizer can not only stabilize the stove, but also isolate the cold ground, which is more important in snow, because the gas tank will take away the heat of the gas tank when it is in direct contact with snow, which makes it difficult for the gas to vaporize and the combustion efficiency is not good.

After the stove is lit, keep upright and don't move. Without complete heating or violent movement, liquefied gas may be directly sent to the nozzle, resulting in sudden fire (the flame is yellow because it is not completely burned in time). Ensure that the control valve is completely closed after use.

6. When replacing the gas tank, the control valve should be closed first to ensure that the flame has been completely extinguished. Take it to an open or well-ventilated place, away from crowds, fire sources and flammable materials. Unscrew the burner and gas tank, and check whether the O-ring and flat gasket are damaged. Then gently screw in the new oil tank to avoid damaging the thread by pushing the wrong tooth hard.