1, first open a CAD drawing as follows.

2, find the output menu under the Page Setup Manager, click, open the following interface. Here is the need to use the page settings in the creation of the layout, it is recommended to directly modify the "Layout 1".

3, click the Modify button, the following page appears. And set up in accordance with the following chart, the following chart, set up and click OK. Note: If there are other requirements, you can choose according to the page prompts. If you don't set it up at once, you can modify it at any time later.

4, return to the following page, directly click Close.

5, click on the layout tab, the following chart. General new drawings come with two layouts, you can directly modify the two layouts, you can also delete the new layout. To modify as an example. Click the following figure.

6, enter the layout page, if the layout already has a viewport, as shown below, then select the viewport, type E, enter, delete it.

7, switch to the Layout menu and add a rectangular viewport, as shown below.

8, click and the Create Viewport option appears as follows.

9, directly type F and enter.

10, inside the viewport type Z, enter. You see the Command option, as follows. Type W, enter. Select the first drawing and drawing 1 will automatically fill the viewport. Double-click outside the viewport to exit the editing viewport, and again follow the figure below for page setup.

11, select the viewport boundary line, the boundary line to a non-printing layer. Click Preview under the Output menu. The preview will look like the following. So a layout is created.