First, you have to be on site, so the workers won't waste too much tiles. If you are not at the scene when sticking tiles, you will waste a lot of bricks when you meet those irresponsible mud workers. It is suggested that some imperfect tiles can be pasted on some invisible places in the future, such as cabinets, sinks, mirrors, etc., but also pay attention to the fact that tiles and waist bricks should not be pasted on the above positions by workers, otherwise you will not see anything in the future and spend money.

Second, make the wall as rough as possible before sticking bricks, which can increase the contact stress area between cement and wall. The specific method is to drill more holes in the wall with an electric drill, and the more the better.

Third, when sticking bricks, you must ask the bricklayer to pull the wire, supplemented by a spirit level. No matter how good the bricklayer's self-blowing skill is and how good he feels, I suggest you insist that he use tools to control the quality.

4. Generally, cement mortar can be used for load-bearing walls. However, 118 glue must be added to the cement mortar to increase the adhesion when sticking bricks on kitchen flue, bathroom air duct and kitchen and bathroom walls with pipes.

5. When the decoration company sticks bricks, the tile trade union holds a ruler made of large core board for you to check and accept. In fact, that thing is not standard after several uses, so you can't use it to check the quality of sticking bricks. You must use a level or aluminum alloy as a ruler to check.

VI. To prevent hollowing, check that the hollowing of tiles should not be knocked just after pasting. It is better to wait for two or three hours before knocking, paying special attention to the four corners of tiles. I suggest that you knock one piece at a time. When you hear the empty drum, you must rework it. Don't be soft-hearted, because if you make do at this time, you will know the harm of empty drum when you finally install something to punch a hole in the tile. At that time, if you punch a hole in the tile, you will want to cry.

VII. The floor of the bathroom must slope to the floor drain, and the slope should be increased appropriately. When decorating the pipes in the bathroom, we should try our best to avoid changing the original drainage and sewage pipes and floor drains, so as to avoid leakage caused by re-arranging pipes and chiseling the floor to damage the waterproof layer.

VIII. If the color of the toner used for tile joint filler is matched, it is best to debug it first and then decide the dosage, otherwise it is either too shallow or too deep.

Nine, the slope of the bathroom decoration floor should be considered before laying bricks. According to the slope of the national standard, the effect of rapid drainage can not be achieved, and if you use odor-resistant floor drain or ultra-thin floor drain, it will greatly aggravate the difficulty of drainage.

11. Don't lay ordinary tiles just because the laundry room is not very important, it must be laid well. Cheap tiles, easy to absorb water, will appear color difference.